Merge tag 'topic/crc-pmic-2015-07-23' of git://anongit.freedesktop.org/drm-intel into drm-next

crystalcove pmic support from Shobhit. Patch series has all acks/r-bs from
other mainainers so ok to pull into drm-next. But I'm cc'ing all other
maintainers as fyi and in case they want to pull it into their trees too
to avoid conflicts.

* tag 'topic/crc-pmic-2015-07-23' of git://anongit.freedesktop.org/drm-intel:
  mfd: Add GPIOLIB dependency if INTEL_SOC_PMIC is to be enabled
  drm/i915: Backlight control using CRC PMIC based PWM driver
  drm/i915: Use the CRC gpio for panel enable/disable
  pwm: crc: Add Crystalcove (CRC) PWM driver
  mfd: intel_soc_pmic_core: ADD PWM lookup table for CRC PMIC based PWM
  mfd: intel_soc_pmic_crc: Add PWM cell device for Crystalcove PMIC
  mfd: intel_soc_pmic_core: Add lookup table for Panel Control as GPIO signal
  gpiolib: Add support for removing registered consumer lookup table

1 files changed, 35 insertions, 2 deletions

diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
index f4438eb..18dd7d7 100644
--- a/drivers/gpu/drm/i915/intel_dsi.c
+++ b/drivers/gpu/drm/i915/intel_dsi.c
@@ -31,6 +31,7 @@
 #include <drm/drm_panel.h>
 #include <drm/drm_mipi_dsi.h>
 #include <linux/slab.h>
+#include <linux/gpio/consumer.h>
 #include "i915_drv.h"
 #include "intel_drv.h"
 #include "intel_dsi.h"
@@ -396,6 +397,8 @@ static void intel_dsi_enable(struct intel_encoder *encoder)
 
 		intel_dsi_port_enable(encoder);
 	}
+
+	intel_panel_enable_backlight(intel_dsi->attached_connector);
 }
 
 static void intel_dsi_pre_enable(struct intel_encoder *encoder)
@@ -410,6 +413,12 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder)
 
 	DRM_DEBUG_KMS("\n");
 
+	/* Panel Enable over CRC PMIC */
+	if (intel_dsi->gpio_panel)
+		gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
+
+	msleep(intel_dsi->panel_on_delay);
+
 	/* Disable DPOunit clock gating, can stall pipe
 	 * and we need DPLL REFA always enabled */
 	tmp = I915_READ(DPLL(pipe));
@@ -427,8 +436,6 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder)
 	/* put device in ready state */
 	intel_dsi_device_ready(encoder);
 
-	msleep(intel_dsi->panel_on_delay);
-
 	drm_panel_prepare(intel_dsi->panel);
 
 	for_each_dsi_port(port, intel_dsi->ports)
@@ -456,6 +463,8 @@ static void intel_dsi_pre_disable(struct intel_encoder *encoder)
 
 	DRM_DEBUG_KMS("\n");
 
+	intel_panel_disable_backlight(intel_dsi->attached_connector);
+
 	if (is_vid_mode(intel_dsi)) {
 		/* Send Shutdown command to the panel in LP mode */
 		for_each_dsi_port(port, intel_dsi->ports)
@@ -571,6 +580,10 @@ static void intel_dsi_post_disable(struct intel_encoder *encoder)
 
 	msleep(intel_dsi->panel_off_delay);
 	msleep(intel_dsi->panel_pwr_cycle_delay);
+
+	/* Panel Disable over CRC PMIC */
+	if (intel_dsi->gpio_panel)
+		gpiod_set_value_cansleep(intel_dsi->gpio_panel, 0);
 }
 
 static bool intel_dsi_get_hw_state(struct intel_encoder *encoder,
@@ -950,6 +963,11 @@ static void intel_dsi_encoder_destroy(struct drm_encoder *encoder)
 		/* XXX: Logically this call belongs in the panel driver. */
 		drm_panel_remove(intel_dsi->panel);
 	}
+
+	/* dispose of the gpios */
+	if (intel_dsi->gpio_panel)
+		gpiod_put(intel_dsi->gpio_panel);
+
 	intel_encoder_destroy(encoder);
 }
 
@@ -1065,6 +1083,20 @@ void intel_dsi_init(struct drm_device *dev)
 		goto err;
 	}
 
+	/*
+	 * In case of BYT with CRC PMIC, we need to use GPIO for
+	 * Panel control.
+	 */
+	if (dev_priv->vbt.dsi.config->pwm_blc == PPS_BLC_PMIC) {
+		intel_dsi->gpio_panel =
+			gpiod_get(dev->dev, "panel", GPIOD_OUT_HIGH);
+
+		if (IS_ERR(intel_dsi->gpio_panel)) {
+			DRM_ERROR("Failed to own gpio for panel control\n");
+			intel_dsi->gpio_panel = NULL;
+		}
+	}
+
 	intel_encoder->type = INTEL_OUTPUT_DSI;
 	intel_encoder->cloneable = 0;
 	drm_connector_init(dev, connector, &intel_dsi_connector_funcs,
@@ -1098,6 +1130,7 @@ void intel_dsi_init(struct drm_device *dev)
 	}
 
 	intel_panel_init(&intel_connector->panel, fixed_mode, NULL);
+	intel_panel_setup_backlight(connector, INVALID_PIPE);
 
 	return;