ACPICA: ACPI 6.2: Add support for PinConfig() resource

ACPICA commit a06fdba686cefccd5dd5b93b52fa0f1e3f984906

ACPI 6.2 introduced a new resource that is used to specify fine-grained
configuration of a pin or set of pins used by a device. The ASL syntax of
this new resource looks like:

  PinConfig (Shared/Exclusive, PinConfigType, PinConfigValue,
             ResourceSource, ResourceSourceIndex, ResourceUsage,
             DescriptorName, Vendordata) {Pin List}

PinConfigType is an integer with following accepted values:

  0x00 (Default) - No configuration is applied to the pin
  0x01 (Bias Pull-up) - Pin is pulled up using certain size resistor
  0x02 (Bias Pull-down) - Pin is pulled down using certain size resistor
  0x03 (Bias Default) - Set to default biasing
  0x04 (Bias Disable) - All bias settings will be disabled
  0x05 (Bias High Impedance) - Configure the pin as hi_z
  0x06 (Bias Bus Hold) - Configure the pin in a weak latch state where
                         it drives the last value on a tristate bus
  0x07 (Drive Open Drain) - Configure the pin into open drain state
  0x08 (Drive Open Source) - Configure the pin into open source state
  0x09 (Drive Push Pull) - Configure the pin into push-pull state
  0x0a (Drive Strength) - How much the pin can supply current
  0x0b (Slew Rate) - Configure slew rate of the pin
  0x0c (Input Debounce) - Enable input debouncer for the pin
  0x0d (Input Schmitt Trigger) - Enable schmitt trigger for the pin
  0x0e - 0x7f - Reserved
  0x80 - 0xff - Vendor defined types

The PinConfigValue depends on the type and is expressed as units
suitable for that type (for example bias uses Ohms).

Link: https://github.com/acpica/acpica/commit/a06fdba6
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Lv Zheng <lv.zheng@intel.com>
Signed-off-by: Bob Moore <robert.moore@intel.com>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>

1 files changed, 6 insertions, 1 deletions

diff --git a/drivers/acpi/acpica/rsinfo.c b/drivers/acpi/acpica/rsinfo.c
index e7310712..5634bd6 100644
--- a/drivers/acpi/acpica/rsinfo.c
+++ b/drivers/acpi/acpica/rsinfo.c
@@ -81,6 +81,7 @@ struct acpi_rsconvert_info *acpi_gbl_set_resource_dispatch[] = {
 	acpi_rs_convert_fixed_dma,	/* 0x12, ACPI_RESOURCE_TYPE_FIXED_DMA */
 	NULL,			/* 0x13, ACPI_RESOURCE_TYPE_SERIAL_BUS - Use subtype table below */
 	acpi_rs_convert_pin_function,	/* 0x14, ACPI_RESOURCE_TYPE_PIN_FUNCTION */
+	acpi_rs_convert_pin_config,	/* 0x15, ACPI_RESOURCE_TYPE_PIN_CONFIG */
 };
 
 /* Dispatch tables for AML-to-resource (Get Resource) conversion functions */
@@ -122,6 +123,7 @@ struct acpi_rsconvert_info *acpi_gbl_get_resource_dispatch[] = {
 	acpi_rs_convert_gpio,	/* 0x0C, ACPI_RESOURCE_NAME_GPIO */
 	acpi_rs_convert_pin_function,	/* 0x0D, ACPI_RESOURCE_NAME_PIN_FUNCTION */
 	NULL,			/* 0x0E, ACPI_RESOURCE_NAME_SERIAL_BUS - Use subtype table below */
+	acpi_rs_convert_pin_config,	/* 0x0F, ACPI_RESOURCE_NAME_PIN_CONFIG */
 };
 
 /* Subtype table for serial_bus -- I2C, SPI, and UART */
@@ -159,6 +161,7 @@ struct acpi_rsdump_info *acpi_gbl_dump_resource_dispatch[] = {
 	acpi_rs_dump_fixed_dma,	/* ACPI_RESOURCE_TYPE_FIXED_DMA */
 	NULL,			/* ACPI_RESOURCE_TYPE_SERIAL_BUS */
 	acpi_rs_dump_pin_function,	/* ACPI_RESOURCE_TYPE_PIN_FUNCTION */
+	acpi_rs_dump_pin_config,	/* ACPI_RESOURCE_TYPE_PIN_CONFIG */
 };
 
 struct acpi_rsdump_info *acpi_gbl_dump_serial_bus_dispatch[] = {
@@ -196,6 +199,7 @@ const u8 acpi_gbl_aml_resource_sizes[] = {
 	sizeof(struct aml_resource_fixed_dma),	/* ACPI_RESOURCE_TYPE_FIXED_DMA */
 	sizeof(struct aml_resource_common_serialbus),	/* ACPI_RESOURCE_TYPE_SERIAL_BUS */
 	sizeof(struct aml_resource_pin_function),	/* ACPI_RESOURCE_TYPE_PIN_FUNCTION */
+	sizeof(struct aml_resource_pin_config),	/* ACPI_RESOURCE_TYPE_PIN_CONFIG */
 };
 
 const u8 acpi_gbl_resource_struct_sizes[] = {
@@ -234,7 +238,8 @@ const u8 acpi_gbl_resource_struct_sizes[] = {
 	ACPI_RS_SIZE(struct acpi_resource_extended_address64),
 	ACPI_RS_SIZE(struct acpi_resource_gpio),
 	ACPI_RS_SIZE(struct acpi_resource_pin_function),
-	ACPI_RS_SIZE(struct acpi_resource_common_serialbus)
+	ACPI_RS_SIZE(struct acpi_resource_common_serialbus),
+	ACPI_RS_SIZE(struct acpi_resource_pin_config),
 };
 
 const u8 acpi_gbl_aml_resource_serial_bus_sizes[] = {