Merge tag 'armsoc-devicetree' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

Pull ARM/arm64 Devicetree updates from Olof Johansson:
 "As usual, device tree updates is the bulk of our material in this
  merge window. This time around, 559 patches affecting both 32- and
  64-bit platforms.

  Changes are too many to list individually, but some of the larger
  ones:

  New platform/SoC support:

   - Automotive:
     + Renesas R-Car D3 (R8A77995)
     + TI DT76x
     + MediaTek mt2712e
   - Communication-oriented:
     + Qualcomm IPQ8074
     + Broadcom Stingray
     + Marvell Armada 8080
   - Set top box:
     + Uniphier PXs3

  Besides some vendor reference boards for the SoC above, there are also
  several new boards/machines:

   - TI AM335x Moxa UC-8100-ME-T open platform
   - TI AM57xx Beaglebone X15 Rev C
   - Microchip/Atmel sama5d27 SoM1 EK
   - Broadcom Raspberry Pi Zero W
   - Gemini-based D-Link DIR-685 router
   - Freescale i.MX6:
     + Toradex Apalis module + Apalis and Ixora carrier boards
     + Engicam GEAM6UL Starter Kit
   - Freescale i.MX53-based Beckhoff CX9020 Embedded PC
   - Mediatek mt7623-based BananaPi R2
   - Several Allwinner-based single-board computers:
  + Cubietruck plus
  + Bananapi M3, M2M and M64
  + NanoPi A64
  + A64-OLinuXino
  + Pine64
   - Rockchip RK3328 Pine64/Rock64 board support
   - Rockchip RK3399 boards:
  + RK3399 Sapphire module on Excavator carrier (RK3399 reference design)
  + Theobroma Systems RK3399-Q7 SoM
   - ZTE ZX296718 PCBOX Board"

* tag 'armsoc-devicetree' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (559 commits)
  ARM: dts: at91: at91sam9g45: add AC97
  arm64: dts: marvell: mcbin: enable more networking ports
  arm64: dts: marvell: add a reference to the sysctrl syscon in the ppv2 node
  arm64: dts: marvell: add TX interrupts for PPv2.2
  arm64: dts: uniphier: add PXs3 SoC support
  ARM: dts: uniphier: add pinctrl groups of ethernet phy mode
  ARM: dts: uniphier: fix size of sdctrl nodes
  ARM: dts: uniphier: add AIDET nodes
  arm64: dts: uniphier: fix size of sdctrl node
  arm64: dts: uniphier: add AIDET nodes
  Revert "ARM: dts: sun8i: h3: Enable dwmac-sun8i on the Beelink X2"
  arm64: dts: uniphier: add reset controller node of analog amplifier
  arm64: dts: marvell: add Device Tree files for Armada-8KP
  arm64: dts: rockchip: add Haikou baseboard with RK3399-Q7 SoM
  arm64: dts: rockchip: add RK3399-Q7 (Puma) SoM
  dt-bindings: add rk3399-q7 SoM
  ARM: dts: rockchip: enable usb for rv1108-evb
  ARM: dts: rockchip: add usb nodes for rv1108 SoCs
  dt-bindings: update grf-binding for rv1108 SoCs
  ARM: dts: aspeed-g4: fix AHB window size of the SMC controllers
  ...

1 files changed, 109 insertions, 3 deletions

diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
index 5d94b5e..eeb7679 100644
--- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
@@ -59,6 +59,14 @@
 		pinctrl-0 = <&pinctrl_mdio1>;
 		gpios = <&gpio6 5 GPIO_ACTIVE_HIGH
 		         &gpio6 4 GPIO_ACTIVE_HIGH>;
+
+		phy: ethernet-phy@0 {
+			pinctrl-0 = <&pinctrl_rmii_phy_irq>;
+			pinctrl-names = "default";
+			reg = <0>;
+			interrupt-parent = <&gpio3>;
+			interrupts = <30 IRQ_TYPE_LEVEL_LOW>;
+		};
 	};
 
 	reg_28p0v: regulator-28p0v {
@@ -615,14 +623,106 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_enet>;
 	phy-mode = "rmii";
+	phy-handle = <&phy>;
 	phy-reset-gpios = <&gpio1 23 GPIO_ACTIVE_LOW>;
 	phy-reset-duration = <100>;
 	phy-supply = <&reg_3p3v>;
 	status = "okay";
 
-	fixed-link {
-		speed = <100>;
-		full-duplex;
+	mdio {
+		#address-cells = <1>;
+		#size-cells = <0>;
+		status = "okay";
+
+		switch: switch@0 {
+			compatible = "marvell,mv88e6085";
+			pinctrl-0 = <&pinctrl_switch_irq>;
+			pinctrl-names = "default";
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <0>;
+			dsa,member = <0 0>;
+			eeprom-length = <512>;
+			interrupt-parent = <&gpio6>;
+			interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+			interrupt-controller;
+			#interrupt-cells = <2>;
+
+			ports {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				port@0 {
+					reg = <0>;
+					label = "gigabit_proc";
+					phy-handle = <&switchphy0>;
+				};
+
+				port@1 {
+					reg = <1>;
+					label = "netaux";
+					phy-handle = <&switchphy1>;
+				};
+
+				port@2 {
+					reg = <2>;
+					label = "cpu";
+					ethernet = <&fec>;
+
+					fixed-link {
+						speed = <100>;
+						full-duplex;
+					};
+				};
+
+				port@3 {
+					reg = <3>;
+					label = "netright";
+					phy-handle = <&switchphy3>;
+				};
+
+				port@4 {
+					reg = <4>;
+					label = "netleft";
+					phy-handle = <&switchphy4>;
+				};
+			};
+
+			mdio {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				switchphy0: switchphy@0 {
+					reg = <0>;
+					interrupt-parent = <&switch>;
+					interrupts = <0 IRQ_TYPE_LEVEL_HIGH>;
+				};
+
+				switchphy1: switchphy@1 {
+					reg = <1>;
+					interrupt-parent = <&switch>;
+					interrupts = <1 IRQ_TYPE_LEVEL_HIGH>;
+				};
+
+				switchphy2: switchphy@2 {
+					reg = <2>;
+					interrupt-parent = <&switch>;
+					interrupts = <2 IRQ_TYPE_LEVEL_HIGH>;
+				};
+
+				switchphy3: switchphy@3 {
+					reg = <3>;
+					interrupt-parent = <&switch>;
+					interrupts = <3 IRQ_TYPE_LEVEL_HIGH>;
+				};
+
+				switchphy4: switchphy@4 {
+					reg = <4>;
+					interrupt-parent = <&switch>;
+					interrupts = <4 IRQ_TYPE_LEVEL_HIGH>;
+				};
+			};
+		};
 	};
 };
 
@@ -840,6 +940,12 @@
 		>;
 	};
 
+	pinctrl_switch_irq: switchgrp {
+		fsl,pins = <
+			MX6QDL_PAD_CSI0_DAT17__GPIO6_IO03	0x4001b000
+		>;
+	};
+
 	pinctrl_tc358767: tc358767grp {
 		fsl,pins = <
 			MX6QDL_PAD_GPIO_9__GPIO1_IO09		0x10