ARM: dts: at91: Switch to the new NAND bindings

Use the new EBI/NAND bindings to declare NAND chips and remove old NAND
nodes along the way.

Note that we keep using old bindings in at91rm9200.dtsi because this
SoC is not supported by the EBI driver.

Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>
Tested-by: Peter Rosin <peda@axentia.se>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>

1 files changed, 36 insertions, 17 deletions

diff --git a/arch/arm/boot/dts/animeo_ip.dts b/arch/arm/boot/dts/animeo_ip.dts
index 9cc372b..26ade8c 100644
--- a/arch/arm/boot/dts/animeo_ip.dts
+++ b/arch/arm/boot/dts/animeo_ip.dts
@@ -83,25 +83,44 @@
 			};
 		};
 
-		nand0: nand@40000000 {
-			nand-bus-width = <8>;
-			nand-ecc-mode = "soft";
-			nand-on-flash-bbt;
+		ebi: ebi@10000000 {
 			status = "okay";
 
-			barebox@0 {
-				label = "barebox";
-				reg = <0x0 0x58000>;
-			};
-
-			u_boot_env@58000 {
-				label = "u_boot_env";
-				reg = <0x58000 0x8000>;
-			};
-
-			ubi@60000 {
-				label = "ubi";
-				reg = <0x60000 0x1FA0000>;
+			nand_controller: nand-controller {
+				status = "okay";
+				pinctrl-0 = <&pinctrl_nand_cs &pinctrl_nand_rb>;
+				pinctrl-names = "default";
+
+				nand@3 {
+					reg = <0x3 0x0 0x800000>;
+					rb-gpios = <&pioC 13 GPIO_ACTIVE_HIGH>;
+					cs-gpios = <&pioC 14 GPIO_ACTIVE_HIGH>;
+					nand-bus-width = <8>;
+					nand-ecc-mode = "soft";
+					nand-on-flash-bbt;
+					label = "atmel_nand";
+
+					partitions {
+						compatible = "fixed-partitions";
+						#address-cells = <1>;
+						#size-cells = <1>;
+
+						barebox@0 {
+							label = "barebox";
+							reg = <0x0 0x58000>;
+						};
+
+						u_boot_env@58000 {
+							label = "u_boot_env";
+							reg = <0x58000 0x8000>;
+						};
+
+						ubi@60000 {
+							label = "ubi";
+							reg = <0x60000 0x1FA0000>;
+						};
+					};
+				};
 			};
 		};