md: support updating bitmap parameters via sysfs.

A new attribute directory 'bitmap' in 'md' is created which
contains files for configuring the bitmap.
'location' identifies where the bitmap is, either 'none',
or 'file' or 'sector offset from metadata'.
Writing 'location' can create or remove a bitmap.
Adding a 'file' bitmap this way is not yet supported.
'chunksize' and 'time_base' must be set before 'location'
can be set.

'chunksize' can be set before creating a bitmap, but is
currently always over-ridden by the bitmap superblock.

'time_base' and 'backlog' can be updated at any time.


Signed-off-by: NeilBrown <neilb@suse.de>
Reviewed-by: Andre Noll <maan@systemlinux.org>

1 files changed, 29 insertions, 0 deletions

diff --git a/Documentation/md.txt b/Documentation/md.txt
index 4edd39e..18fad68 100644
--- a/Documentation/md.txt
+++ b/Documentation/md.txt
@@ -296,6 +296,35 @@ All md devices contain:
      active-idle
          like active, but no writes have been seen for a while (safe_mode_delay).
 
+  bitmap/location
+     This indicates where the write-intent bitmap for the array is
+     stored.
+     It can be one of "none", "file" or "[+-]N".
+     "file" may later be extended to "file:/file/name"
+     "[+-]N" means that many sectors from the start of the metadata.
+       This is replicated on all devices.  For arrays with externally
+       managed metadata, the offset is from the beginning of the
+       device.
+  bitmap/chunksize
+     The size, in bytes, of the chunk which will be represented by a
+     single bit.  For RAID456, it is a portion of an individual
+     device. For RAID10, it is a portion of the array.  For RAID1, it
+     is both (they come to the same thing).
+  bitmap/time_base
+     The time, in seconds, between looking for bits in the bitmap to
+     be cleared. In the current implementation, a bit will be cleared
+     between 2 and 3 times "time_base" after all the covered blocks
+     are known to be in-sync.
+  bitmap/backlog
+     When write-mostly devices are active in a RAID1, write requests
+     to those devices proceed in the background - the filesystem (or
+     other user of the device) does not have to wait for them.
+     'backlog' sets a limit on the number of concurrent background
+     writes.  If there are more than this, new writes will by
+     synchronous.
+     
+     
+     
 
 As component devices are added to an md array, they appear in the 'md'
 directory as new directories named