Merge branch 'x86-platform-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip

* 'x86-platform-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip: (27 commits)
  x86: Clean up apic.c and apic.h
  x86: Remove superflous goal definition of tsc_sync
  x86: dt: Correct local apic documentation in device tree bindings
  x86: dt: Cleanup local apic setup
  x86: dt: Fix OLPC=y/INTEL_CE=n build
  rtc: cmos: Add OF bindings
  x86: ce4100: Use OF to setup devices
  x86: ioapic: Add OF bindings for IO_APIC
  x86: dtb: Add generic bus probe
  x86: dtb: Add support for PCI devices backed by dtb nodes
  x86: dtb: Add device tree support for HPET
  x86: dtb: Add early parsing of IO_APIC
  x86: dtb: Add irq domain abstraction
  x86: dtb: Add a device tree for CE4100
  x86: Add device tree support
  x86: e820: Remove conditional early mapping in parse_e820_ext
  x86: OLPC: Make OLPC=n build again
  x86: OLPC: Remove extra OLPC_OPENFIRMWARE_DT indirection
  x86: OLPC: Cleanup config maze completely
  x86: OLPC: Hide OLPC_OPENFIRMWARE config switch
  ...

Fix up conflicts in arch/x86/platform/ce4100/ce4100.c

1 files changed, 20 insertions, 0 deletions

diff --git a/Documentation/devicetree/booting-without-of.txt b/Documentation/devicetree/booting-without-of.txt
index 28b1c9d..55fd262 100644
--- a/Documentation/devicetree/booting-without-of.txt
+++ b/Documentation/devicetree/booting-without-of.txt
@@ -13,6 +13,7 @@ Table of Contents
 
   I - Introduction
     1) Entry point for arch/powerpc
+    2) Entry point for arch/x86
 
   II - The DT block format
     1) Header
@@ -225,6 +226,25 @@ it with special cases.
   cannot support both configurations with Book E and configurations
   with classic Powerpc architectures.
 
+2) Entry point for arch/x86
+-------------------------------
+
+  There is one single 32bit entry point to the kernel at code32_start,
+  the decompressor (the real mode entry point goes to the same  32bit
+  entry point once it switched into protected mode). That entry point
+  supports one calling convention which is documented in
+  Documentation/x86/boot.txt
+  The physical pointer to the device-tree block (defined in chapter II)
+  is passed via setup_data which requires at least boot protocol 2.09.
+  The type filed is defined as
+
+  #define SETUP_DTB                      2
+
+  This device-tree is used as an extension to the "boot page". As such it
+  does not parse / consider data which is already covered by the boot
+  page. This includes memory size, reserved ranges, command line arguments
+  or initrd address. It simply holds information which can not be retrieved
+  otherwise like interrupt routing or a list of devices behind an I2C bus.
 
 II - The DT block format
 ========================