1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
|
#ifndef __FMOPL_H_
#define __FMOPL_H_
/* --- select emulation chips --- */
#define BUILD_YM3812 (HAS_YM3812)
//#define BUILD_YM3526 (HAS_YM3526)
//#define BUILD_Y8950 (HAS_Y8950)
/* --- system optimize --- */
/* select bit size of output : 8 or 16 */
#define OPL_OUTPUT_BIT 16
/* compiler dependence */
#ifndef OSD_CPU_H
#define OSD_CPU_H
typedef unsigned char UINT8; /* unsigned 8bit */
typedef unsigned short UINT16; /* unsigned 16bit */
typedef unsigned int UINT32; /* unsigned 32bit */
typedef signed char INT8; /* signed 8bit */
typedef signed short INT16; /* signed 16bit */
typedef signed int INT32; /* signed 32bit */
#endif
#if (OPL_OUTPUT_BIT==16)
typedef INT16 OPLSAMPLE;
#endif
#if (OPL_OUTPUT_BIT==8)
typedef unsigned char OPLSAMPLE;
#endif
#if BUILD_Y8950
#include "ymdeltat.h"
#endif
typedef void (*OPL_TIMERHANDLER)(int channel,double interval_Sec);
typedef void (*OPL_IRQHANDLER)(int param,int irq);
typedef void (*OPL_UPDATEHANDLER)(int param,int min_interval_us);
typedef void (*OPL_PORTHANDLER_W)(int param,unsigned char data);
typedef unsigned char (*OPL_PORTHANDLER_R)(int param);
/* !!!!! here is private section , do not access there member direct !!!!! */
#define OPL_TYPE_WAVESEL 0x01 /* waveform select */
#define OPL_TYPE_ADPCM 0x02 /* DELTA-T ADPCM unit */
#define OPL_TYPE_KEYBOARD 0x04 /* keyboard interface */
#define OPL_TYPE_IO 0x08 /* I/O port */
/* Saving is necessary for member of the 'R' mark for suspend/resume */
/* ---------- OPL one of slot ---------- */
typedef struct fm_opl_slot {
INT32 TL; /* total level :TL << 8 */
INT32 TLL; /* adjusted now TL */
UINT8 KSR; /* key scale rate :(shift down bit) */
INT32 *AR; /* attack rate :&AR_TABLE[AR<<2] */
INT32 *DR; /* decay rate :&DR_TALBE[DR<<2] */
INT32 SL; /* sustin level :SL_TALBE[SL] */
INT32 *RR; /* release rate :&DR_TABLE[RR<<2] */
UINT8 ksl; /* keyscale level :(shift down bits) */
UINT8 ksr; /* key scale rate :kcode>>KSR */
UINT32 mul; /* multiple :ML_TABLE[ML] */
UINT32 Cnt; /* frequency count : */
UINT32 Incr; /* frequency step : */
/* envelope generator state */
UINT8 eg_typ; /* envelope type flag */
UINT8 evm; /* envelope phase */
INT32 evc; /* envelope counter */
INT32 eve; /* envelope counter end point */
INT32 evs; /* envelope counter step */
INT32 evsa; /* envelope step for AR :AR[ksr] */
INT32 evsd; /* envelope step for DR :DR[ksr] */
INT32 evsr; /* envelope step for RR :RR[ksr] */
/* LFO */
UINT8 ams; /* ams flag */
UINT8 vib; /* vibrate flag */
/* wave selector */
INT32 **wavetable;
}OPL_SLOT;
/* ---------- OPL one of channel ---------- */
typedef struct fm_opl_channel {
OPL_SLOT SLOT[2];
UINT8 CON; /* connection type */
UINT8 FB; /* feed back :(shift down bit) */
INT32 *connect1; /* slot1 output pointer */
INT32 *connect2; /* slot2 output pointer */
INT32 op1_out[2]; /* slot1 output for selfeedback */
/* phase generator state */
UINT32 block_fnum; /* block+fnum : */
UINT8 kcode; /* key code : KeyScaleCode */
UINT32 fc; /* Freq. Increment base */
UINT32 ksl_base; /* KeyScaleLevel Base step */
UINT8 keyon; /* key on/off flag */
} OPL_CH;
/* OPL state */
typedef struct fm_opl_f {
UINT8 type; /* chip type */
int clock; /* master clock (Hz) */
int rate; /* sampling rate (Hz) */
double freqbase; /* frequency base */
double TimerBase; /* Timer base time (==sampling time) */
UINT8 address; /* address register */
UINT8 status; /* status flag */
UINT8 statusmask; /* status mask */
UINT32 mode; /* Reg.08 : CSM , notesel,etc. */
/* Timer */
int T[2]; /* timer counter */
UINT8 st[2]; /* timer enable */
/* FM channel slots */
OPL_CH *P_CH; /* pointer of CH */
int max_ch; /* maximum channel */
/* Rhythm sention */
UINT8 rhythm; /* Rhythm mode , key flag */
#if BUILD_Y8950
/* Delta-T ADPCM unit (Y8950) */
YM_DELTAT *deltat; /* DELTA-T ADPCM */
#endif
/* Keyboard / I/O interface unit (Y8950) */
UINT8 portDirection;
UINT8 portLatch;
OPL_PORTHANDLER_R porthandler_r;
OPL_PORTHANDLER_W porthandler_w;
int port_param;
OPL_PORTHANDLER_R keyboardhandler_r;
OPL_PORTHANDLER_W keyboardhandler_w;
int keyboard_param;
/* time tables */
INT32 AR_TABLE[75]; /* atttack rate tables */
INT32 DR_TABLE[75]; /* decay rate tables */
UINT32 FN_TABLE[1024]; /* fnumber -> increment counter */
/* LFO */
INT32 *ams_table;
INT32 *vib_table;
INT32 amsCnt;
INT32 amsIncr;
INT32 vibCnt;
INT32 vibIncr;
/* wave selector enable flag */
UINT8 wavesel;
/* external event callback handler */
OPL_TIMERHANDLER TimerHandler; /* TIMER handler */
int TimerParam; /* TIMER parameter */
OPL_IRQHANDLER IRQHandler; /* IRQ handler */
int IRQParam; /* IRQ parameter */
OPL_UPDATEHANDLER UpdateHandler; /* stream update handler */
int UpdateParam; /* stream update parameter */
} FM_OPL;
/* ---------- Generic interface section ---------- */
#define OPL_TYPE_YM3526 (0)
#define OPL_TYPE_YM3812 (OPL_TYPE_WAVESEL)
#define OPL_TYPE_Y8950 (OPL_TYPE_ADPCM|OPL_TYPE_KEYBOARD|OPL_TYPE_IO)
FM_OPL *OPLCreate(int type, int clock, int rate);
void OPLDestroy(FM_OPL *OPL);
void OPLSetTimerHandler(FM_OPL *OPL,OPL_TIMERHANDLER TimerHandler,int channelOffset);
void OPLSetIRQHandler(FM_OPL *OPL,OPL_IRQHANDLER IRQHandler,int param);
void OPLSetUpdateHandler(FM_OPL *OPL,OPL_UPDATEHANDLER UpdateHandler,int param);
/* Y8950 port handlers */
void OPLSetPortHandler(FM_OPL *OPL,OPL_PORTHANDLER_W PortHandler_w,OPL_PORTHANDLER_R PortHandler_r,int param);
void OPLSetKeyboardHandler(FM_OPL *OPL,OPL_PORTHANDLER_W KeyboardHandler_w,OPL_PORTHANDLER_R KeyboardHandler_r,int param);
void OPLResetChip(FM_OPL *OPL);
int OPLWrite(FM_OPL *OPL,int a,int v);
unsigned char OPLRead(FM_OPL *OPL,int a);
int OPLTimerOver(FM_OPL *OPL,int c);
/* YM3626/YM3812 local section */
void YM3812UpdateOne(FM_OPL *OPL, INT16 *buffer, int length);
void Y8950UpdateOne(FM_OPL *OPL, INT16 *buffer, int length);
#endif
|
