From 13d8cc515dfcf5574077f964332d34890c0101d0 Mon Sep 17 00:00:00 2001 From: Jeff Cody Date: Wed, 25 Jun 2014 15:40:11 -0400 Subject: block: add backing-file option to block-stream On some image chains, QEMU may not always be able to resolve the filenames properly, when updating the backing file of an image after a block job. For instance, certain relative pathnames may fail, or drives may have been specified originally by file descriptor (e.g. /dev/fd/???), or a relative protocol pathname may have been used. In these instances, QEMU may lack the information to be able to make the correct choice, but the user or management layer most likely does have that knowledge. With this extension to the block-stream api, the user is able to change the backing file of the active layer as part of the block-stream operation. This allows the change to be 'safe', in the sense that if the attempt to write the active image metadata fails, then the block-stream operation returns failure, without disrupting the guest. If a backing file string is not specified in the command, the backing file string to use is determined in the same manner as it was previously. Reviewed-by: Eric Blake Signed-off-by: Jeff Cody Signed-off-by: Stefan Hajnoczi --- qapi/block-core.json | 19 +++++++++++++++++-- 1 file changed, 17 insertions(+), 2 deletions(-) (limited to 'qapi') diff --git a/qapi/block-core.json b/qapi/block-core.json index 5b4d75f..e378653 100644 --- a/qapi/block-core.json +++ b/qapi/block-core.json @@ -922,6 +922,21 @@ # # @base: #optional the common backing file name # +# @backing-file: #optional The backing file string to write into the active +# layer. This filename is not validated. +# +# If a pathname string is such that it cannot be +# resolved by QEMU, that means that subsequent QMP or +# HMP commands must use node-names for the image in +# question, as filename lookup methods will fail. +# +# If not specified, QEMU will automatically determine +# the backing file string to use, or error out if there +# is no obvious choice. Care should be taken when +# specifying the string, to specify a valid filename or +# protocol. +# (Since 2.1) +# # @speed: #optional the maximum speed, in bytes per second # # @on-error: #optional the action to take on an error (default report). @@ -934,8 +949,8 @@ # Since: 1.1 ## { 'command': 'block-stream', - 'data': { 'device': 'str', '*base': 'str', '*speed': 'int', - '*on-error': 'BlockdevOnError' } } + 'data': { 'device': 'str', '*base': 'str', '*backing-file': 'str', + '*speed': 'int', '*on-error': 'BlockdevOnError' } } ## # @block-job-set-speed: -- cgit v1.1