diff options
Diffstat (limited to 'flashrom.8.tmpl')
-rw-r--r-- | flashrom.8.tmpl | 34 |
1 files changed, 32 insertions, 2 deletions
diff --git a/flashrom.8.tmpl b/flashrom.8.tmpl index 799d5b9..8b5f98c 100644 --- a/flashrom.8.tmpl +++ b/flashrom.8.tmpl @@ -229,6 +229,8 @@ bitbanging adapter) .sp .BR "* mstarddc_spi" " (for SPI flash ROMs accessible through DDC in MSTAR-equipped displays)" .sp +.BR "* pickit2_spi" " (for SPI flash ROMs accessible via Microchip PICkit2)" +.sp Some programmers have optional or mandatory parameters which are described in detail in the .B PROGRAMMER-SPECIFIC INFORMATION @@ -736,6 +738,34 @@ More information about the Bus Pirate pull-up resistors and their purpose is ava .BR "http://dangerousprototypes.com/docs/Practical_guide_to_Bus_Pirate_pull-up_resistors " . Only the external supply voltage (Vpu) is supported as of this writing. .SS +.BR "pickit2_spi " programmer +An optional +.B voltage +parameter specifies the voltage the PICkit2 should use. The default unit is Volt if no unit is specified. +You can use +.BR mV ", " millivolt ", " V " or " Volt +as unit specifier. Syntax is +.sp +.B " flashrom \-p pickit2_spi:voltage=value" +.sp +where +.B value +can be +.BR 0V ", " 1.8V ", " 2.5V ", " 3.5V +or the equivalent in mV. +.sp +An optional +.B spispeed +parameter specifies the frequency of the SPI bus. Syntax is +.sp +.B " flashrom \-p pickit2_spi:spispeed=frequency" +.sp +where +.B frequency +can be +.BR 250k ", " 333k ", " 500k " or " 1M " +(in Hz). The default is a frequency of 1 MHz. +.SS .BR "dediprog " programmer An optional .B voltage @@ -992,7 +1022,7 @@ needs TCP access to the network or userspace access to a serial port. .B buspirate_spi needs userspace access to a serial port. .sp -.BR dediprog ", " ft2232_spi " and " usbblaster_spi +.BR dediprog ", " ft2232_spi " and " usbblaster_spi and " pickit2_spi need access to the USB device via libusb. .sp .B dummy @@ -1002,7 +1032,7 @@ needs no access permissions at all. .BR gfxnvidia ", " drkaiser ", " satasii ", " satamv ", " atahpt" and " atavia have to be run as superuser/root, and need additional raw access permission. .sp -.BR serprog ", " buspirate_spi ", " dediprog ", " usbblaster_spi " and " ft2232_spi +.BR serprog ", " buspirate_spi ", " dediprog ", " usbblaster_spi " and " ft2232_spi and " pickit2_spi can be run as normal user on most operating systems if appropriate device permissions are set. .sp |