Add new programmer for SPI EEPROMs attached to Intel 82580 NICs

This patch lets you read and write the EEPROM on 82580-based gigabit NIC
cards. So far it has been tested on copper NICs only, but other variants
employing this controller should work too.
It is a nice substitution for the official eeupdate tool.

Speed is quite decent: less than 4 seconds for erases or writes of 32 kB.

Tested-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>

Corresponding to flashrom svn r1832.

Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>
Signed-off-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
Acked-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>

1 files changed, 12 insertions, 0 deletions

diff --git a/flashrom.c b/flashrom.c
index 83bc89a..fc8b073 100644
--- a/flashrom.c
+++ b/flashrom.c
@@ -297,6 +297,18 @@ const struct programmer_entry programmer_table[] = {
 	},
 #endif
 
+#if CONFIG_NICINTEL_EEPROM == 1
+	{
+		.name			= "nicintel_eeprom",
+		.type			= PCI,
+		.devs.dev		= nics_intel_ee,
+		.init			= nicintel_ee_init,
+		.map_flash_region	= fallback_map,
+		.unmap_flash_region	= fallback_unmap,
+		.delay			= internal_delay,
+	},
+#endif
+
 #if CONFIG_OGP_SPI == 1
 	{
 		.name			= "ogp_spi",