From e7fdd6e9a17129da53b8f4104b58899b5a011458 Mon Sep 17 00:00:00 2001 From: Carl-Daniel Hailfinger Date: Wed, 21 Jul 2010 10:26:01 +0000 Subject: Add support for RayeR SPIPGM hardware as described in http://rayer.ic.cz/elektro/spipgm.htm To use the RayeR driver, run flashrom -p rayer_spi -V Known bugs/limitations: - Won't compile/work on non-x86 architectures. - Will always use direct port I/O access. Log follows: flashrom v0.9.2-r1039 on MS-DOS 7 (i686), built with libpci 3.1.5, GCC 4.3.2, little endian Calibrating delay loop... OK. Initializing rayer_bitbang_spi programmer Using port 0x378 as I/O base for parallel port access. ... Probing for Macronix MX25L1605, 2048 KB: probe_spi_rdid_generic: id1 0xc2, id2 0x2015 ... Found chip "Macronix MX25L1605" (2048 KB, SPI) at physical address 0xffe00000. ... No operations were specified. Corresponding to flashrom svn r1093. Signed-off-by: Carl-Daniel Hailfinger Acked-by: Martin Rehak Acked-by: Michael Karcher --- spi.c | 9 +++++++++ 1 file changed, 9 insertions(+) (limited to 'spi.c') diff --git a/spi.c b/spi.c index 2b64463..1efdae0 100644 --- a/spi.c +++ b/spi.c @@ -121,6 +121,15 @@ const struct spi_programmer spi_programmer[] = { }, #endif +#if CONFIG_RAYER_SPI == 1 + { /* SPI_CONTROLLER_RAYER */ + .command = bitbang_spi_send_command, + .multicommand = default_spi_send_multicommand, + .read = bitbang_spi_read, + .write_256 = bitbang_spi_write_256, + }, +#endif + {}, /* This entry corresponds to SPI_CONTROLLER_INVALID. */ }; -- cgit v1.1