From 92fefc921a602acb89a897193c9f31fbb78d85b5 Mon Sep 17 00:00:00 2001 From: Stefan Tauner Date: Sat, 27 Oct 2012 00:34:23 +0000 Subject: serprog: add opcode to control the programmer's output drivers This allowed me to let the clips remain attached on my D946GZIS while playing with coreboot/serialice. Corresponding to flashrom svn r1618. Signed-off-by: Stefan Tauner Acked-by: Stefan Tauner --- Documentation/serprog-protocol.txt | 7 +++++++ 1 file changed, 7 insertions(+) (limited to 'Documentation') diff --git a/Documentation/serprog-protocol.txt b/Documentation/serprog-protocol.txt index 821cf28..58f4417 100644 --- a/Documentation/serprog-protocol.txt +++ b/Documentation/serprog-protocol.txt @@ -34,6 +34,7 @@ COMMAND Description Parameters Return Value 0x13 Perform SPI operation 24-bit slen + 24-bit rlen ACK + rlen bytes of data / NAK + slen bytes of data 0x14 Set SPI clock frequency in Hz 32-bit requested frequency ACK + 32-bit set frequency / NAK +0x15 Toggle flash chip pin drivers 8-bit (0 disable, else enable) ACK / NAK 0x?? unimplemented command - invalid. @@ -82,6 +83,12 @@ Additional information of the above commands: lower than the one requested. If there is no lower frequency available the lowest possible should be used. The value chosen is sent back in the reply with an ACK. + 0x15 (S_CMD_S_PIN_STATE): + Sets the state of the pin drivers connected to the flash chip. Disabling them allows other + devices (e.g. a mainboard's chipset) to access the chip. This way the serprog controller can + remain attached to the flash chip even when the board is running. The user is responsible to + NOT connect VCC and other permanently externally driven signals to the programmer as needed. + If the value is 0, then the drivers should be disabled, otherwise they should be enabled. About mandatory commands: The only truly mandatory commands for any device are 0x00, 0x01, 0x02 and 0x10, but one can't really do anything with these commands. -- cgit v1.1