diff options
Diffstat (limited to 'flashrom.8')
| -rw-r--r-- | flashrom.8 | 16 |
1 files changed, 8 insertions, 8 deletions
@@ -150,7 +150,7 @@ Specify the programmer device. Currently supported are: .sp The dummy programmer has an optional parameter specifying the bus types it should support. For that you have to use the -.B "flashrom -p dummy=type" +.B "flashrom -p dummy:type" syntax where .B type can be any comma-separated combination of @@ -158,11 +158,11 @@ can be any comma-separated combination of in any order. .sp Example: -.B "flashrom -p dummy=lpc,fwh" +.B "flashrom -p dummy:lpc,fwh" .sp If you have multiple supported PCI cards which can program flash chips (NICs, SATA/IDE controllers, etc.) in your system, you must use the -.B "flashrom -p xxxx=bb:dd.f" +.B "flashrom -p xxxx:bb:dd.f" syntax to explicitly select one of them, where .B xxxx is the name of the programmer @@ -174,7 +174,7 @@ is the PCI device number, and is the PCI function number of the desired NIC. .sp Example: -.B "flashrom -p nic3com=05:04.0" +.B "flashrom -p nic3com:05:04.0" .sp Currently the following programmers support this mechanism: .BR nic3com , @@ -183,14 +183,14 @@ Currently the following programmers support this mechanism: The it87spi programmer has an optional parameter which will set the I/O base port of the IT87* SPI controller interface to the port specified in the parameter. For that you have to use the -.B "flashrom -p it87spi=port=portnum" +.B "flashrom -p it87spi:port=portnum" syntax where .B portnum is an I/O port number which must be a multiple of 8. .sp The ft2232spi programmer has an optional parameter specifying the controller type and interface/port it should support. For that you have to use the -.B "flashrom -p ft2232spi=model,port=interface" +.B "flashrom -p ft2232spi:model,port=interface" syntax where .B model can be any of @@ -208,9 +208,9 @@ and the default interface is The serprog programmer has an optional parameter specifying either a serial device/baud combination or an IP/port combination for communication with the programmer. For serial, you have to use the -.B "flashrom -p serprog=/dev/device:baud" +.B "flashrom -p serprog:/dev/device:baud" syntax and for IP, you have to use -.B "flashrom -p serprog=ip:port" +.B "flashrom -p serprog:ip:port" instead. More information about serprog is available in serprog-protocol.txt in the source distribution. .sp |
