/*- * Copyright (c) 2016 Adrian Chadd * All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer, * without modification. * 2. Redistributions in binary form must reproduce at minimum a disclaimer * similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any * redistribution must be conditioned upon including a substantially * similar Disclaimer requirement for further binary redistribution. * * NO WARRANTY * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY * AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL * THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, * OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER * IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF * THE POSSIBILITY OF SUCH DAMAGES. */ #include __FBSDID("$FreeBSD$"); /* * This is the top-level N-PHY support for the Broadcom softmac driver. */ #include "opt_bwn.h" #include "opt_wlan.h" #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #ifdef BWN_GPL_PHY #include #include #include #endif /* * This module is always compiled into the kernel, regardless of * whether the GPL PHY is enabled. If the GPL PHY isn't enabled * then it'll just be stubs that will fail to attach. */ int bwn_phy_n_attach(struct bwn_mac *mac) { #ifdef BWN_GPL_PHY return bwn_nphy_op_allocate(mac); #else device_printf(mac->mac_sc->sc_dev, "%s: BWN_GPL_PHY not in kernel config; " "no PHY-N support\n", __func__); return (ENXIO); #endif } void bwn_phy_n_detach(struct bwn_mac *mac) { #ifdef BWN_GPL_PHY return bwn_nphy_op_free(mac); #endif } int bwn_phy_n_prepare_hw(struct bwn_mac *mac) { #ifdef BWN_GPL_PHY bwn_nphy_op_prepare_structs(mac); return (0); #else return (ENXIO); #endif } void bwn_phy_n_init_pre(struct bwn_mac *mac) { /* XXX TODO */ } int bwn_phy_n_init(struct bwn_mac *mac) { #ifdef BWN_GPL_PHY return bwn_nphy_op_init(mac); #else return (ENXIO); #endif } void bwn_phy_n_exit(struct bwn_mac *mac) { /* XXX TODO */ } uint16_t bwn_phy_n_read(struct bwn_mac *mac, uint16_t reg) { BWN_WRITE_2(mac, BWN_PHYCTL, reg); return BWN_READ_2(mac, BWN_PHYDATA); } void bwn_phy_n_write(struct bwn_mac *mac, uint16_t reg, uint16_t value) { BWN_WRITE_2(mac, BWN_PHYCTL, reg); BWN_WRITE_2(mac, BWN_PHYDATA, value); } uint16_t bwn_phy_n_rf_read(struct bwn_mac *mac, uint16_t reg) { /* Register 1 is a 32-bit register. */ if (mac->mac_phy.rev < 7 && reg == 1) { BWN_ERRPRINTF(mac->mac_sc, "%s: bad reg access\n", __func__); } if (mac->mac_phy.rev >= 7) reg |= 0x200; /* radio 0x2057 */ else reg |= 0x100; BWN_WRITE_2(mac, BWN_RFCTL, reg); return BWN_READ_2(mac, BWN_RFDATALO); } void bwn_phy_n_rf_write(struct bwn_mac *mac, uint16_t reg, uint16_t value) { /* Register 1 is a 32-bit register. */ if (mac->mac_phy.rev < 7 && reg == 1) { BWN_ERRPRINTF(mac->mac_sc, "%s: bad reg access\n", __func__); } BWN_WRITE_2(mac, BWN_RFCTL, reg); BWN_WRITE_2(mac, BWN_RFDATALO, value); } int bwn_phy_n_hwpctl(struct bwn_mac *mac) { return (0); } void bwn_phy_n_rf_onoff(struct bwn_mac *mac, int on) { #ifdef BWN_GPL_PHY bwn_nphy_op_software_rfkill(mac, on); #endif } void bwn_phy_n_switch_analog(struct bwn_mac *mac, int on) { #ifdef BWN_GPL_PHY bwn_nphy_op_switch_analog(mac, on); #endif } int bwn_phy_n_switch_channel(struct bwn_mac *mac, uint32_t newchan) { #ifdef BWN_GPL_PHY return bwn_nphy_op_switch_channel(mac, newchan); #else return (ENXIO); #endif } uint32_t bwn_phy_n_get_default_chan(struct bwn_mac *mac) { if (bwn_current_band(mac) == BWN_BAND_2G) return (1); return (36); } void bwn_phy_n_set_antenna(struct bwn_mac *mac, int antenna) { /* XXX TODO */ } int bwn_phy_n_im(struct bwn_mac *mac, int mode) { /* XXX TODO */ return (0); } bwn_txpwr_result_t bwn_phy_n_recalc_txpwr(struct bwn_mac *mac, int ignore_tssi) { #ifdef BWN_GPL_PHY return bwn_nphy_op_recalc_txpower(mac, ignore_tssi); #else return (BWN_TXPWR_RES_DONE); #endif } void bwn_phy_n_set_txpwr(struct bwn_mac *mac) { } void bwn_phy_n_task_15s(struct bwn_mac *mac) { } void bwn_phy_n_task_60s(struct bwn_mac *mac) { }