.\" Copyright 2002-2007 Sandvine Inc. .\" All rights reserved. .\" .\" Subject to the following obligations and disclaimer of warranty, use and .\" redistribution of this software, in source or object code forms, with or .\" without modifications are expressly permitted by Sandvine Inc.; provided, .\" however, that: .\" 1. Any and all reproductions of the source or object code must include the .\" copyright notice above and the following disclaimer of warranties; and .\" 2. No rights are granted, in any manner or form, to use Sandvine Inc. .\" trademarks, including the mark "SANDVINE" on advertising, endorsements, .\" or otherwise except as such appears in the above copyright notice or in .\" the software. .\" .\" THIS SOFTWARE IS BEING PROVIDED BY SANDVINE "AS IS", AND TO THE MAXIMUM .\" EXTENT PERMITTED BY LAW, SANDVINE MAKES NO REPRESENTATIONS OR WARRANTIES, .\" EXPRESS OR IMPLIED, REGARDING THIS SOFTWARE, INCLUDING WITHOUT LIMITATION, .\" ANY AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR .\" PURPOSE, OR NON-INFRINGEMENT. SANDVINE DOES NOT WARRANT, GUARANTEE, OR .\" MAKE ANY REPRESENTATIONS REGARDING THE USE OF, OR THE RESULTS OF THE .\" USE OF THIS SOFTWARE IN TERMS OF ITS CORRECTNESS, ACCURACY, RELIABILITY .\" OR OTHERWISE. IN NO EVENT SHALL SANDVINE BE LIABLE FOR ANY DAMAGES .\" RESULTING FROM OR ARISING OUT OF ANY USE OF THIS SOFTWARE, INCLUDING .\" WITHOUT LIMITATION, ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, .\" PUNITIVE, OR CONSEQUENTIAL DAMAGES, PROCUREMENT OF SUBSTITUTE GOODS OR .\" SERVICES, LOSS OF USE, DATA OR PROFITS, HOWEVER CAUSED AND UNDER ANY .\" THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT .\" (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF .\" THIS SOFTWARE, EVEN IF SANDVINE IS ADVISED OF THE POSSIBILITY OF SUCH .\" DAMAGE. .\" .\" Author: Dave Chapeskie .\" $FreeBSD$ .\" .Dd March 1, 2007 .Dt NG_SOURCE 4 .Os .Sh NAME .Nm ng_source .Nd netgraph node for traffic generation .Sh SYNOPSIS .In sys/types.h .In netgraph/ng_source.h .Sh DESCRIPTION The .Nm source node acts as a source of packets according to the parameters set up using control messages and input packets. The .Nm node type is used primarily for testing and benchmarking. .Sh HOOKS The .Nm source node has two hooks: .Va input and .Va output . The .Va output hook must remain connected, its disconnection will shutdown the node. .Sh OPERATION The operation of the node is as follows. Packets received on the .Va input hook are queued internally. When .Va output hook is connected, .Nm node assumes that its neighbour node is of .Xr ng_ether 4 node type. The neighbour is queried for its interface name. The .Nm node then uses queue of the interface for its evil purposes. The .Nm node also disables .Va autosrc option on neighbour .Xr ng_ether 4 node. If interface name cannot be obtained automatically, it should be configured explicitly with the .Dv NGM_SOURCE_SETIFACE control message, and .Va autosrc should be turned off on .Xr ng_ether 4 node manually. .Pp Once interface is configured, upon receipt of a .Dv NGM_SOURCE_START control message the node starts sending the previously queued packets out the .Va output hook on every clock tick as fast as the connected interface will take them. While active, on every clock tick the node checks the available space in the interface queue and sends that many packets out its .Va output hook. Once the number of packets indicated in the start message has been sent, or upon receipt of a .Dv NGM_SOURCE_STOP message, the node stops sending data. .Sh CONTROL MESSAGES This node type supports the generic control messages as well as the following, which must be sent with the .Dv NGM_SOURCE_COOKIE attached. .Bl -tag -width foo .It Dv NGM_SOURCE_GET_STATS Pq Ic getstats Returns a structure containing the following fields: .Bl -tag -width ".Va elapsedTime" .It Va outOctets The number of octets/bytes sent out the .Va output hook. .It Va outFrames The number of frames/packets sent out the .Va output hook. .It Va queueOctets The number of octets queued from the .Va input hook. .It Va queueFrames The number of frames queued from the .Va input hook. .It Va startTime The time the last start message was received. .It Va endTime The time the last end message was received or the output packet count was reached. .It Va elapsedTime Either .Va endTime Li \- Va startTime or current time \- .Va startTime . .El .It Dv NGM_SOURCE_CLR_STATS Pq Ic clrstats Clears and resets the statistics returned by .Ic getstats (except .Va queueOctets and .Va queueFrames ) . .It Dv NGM_SOURCE_GETCLR_STATS Pq Ic getclrstats As .Ic getstats but clears the statistics at the same time. .It Dv NGM_SOURCE_START Pq Ic start This message requires a single .Vt uint64_t parameter which is the number of packets to send before stopping. Node starts sending the queued packets out the .Va output hook. The .Va output hook must be connected and node must have interface configured. .It Dv NGM_SOURCE_STOP Pq Ic stop Stops the node if it is active. .It Dv NGM_SOURCE_CLR_DATA Pq Ic clrdata Clears the packets queued from the .Va input hook. .It Dv NGM_SOURCE_SETIFACE Pq Ic setiface This message requires the name of the interface to be configured as an argument. .It Dv NGM_SOURCE_SETPPS Pq Ic setpps This message requires a single .Vt uint32_t parameter which puts upper limit on the amount of packets sent per second. .It Dv NGM_SOURCE_SET_TIMESTAMP Pq Ic settimestamp This message specifies that a timestamp (in the format of a .Vt "struct timeval" ) should be inserted in the transmitted packets. This message requires a structure containing the following fields: .Bl -tag -width ".Va offset" .It Va offset The offset from the beginning of the packet at which the timestamp is to be inserted. .It Va flags Set to 1 to enable the timestamp. .El .It Dv NGM_SOURCE_GET_TIMESTAMP Pq Ic gettimestamp Returns the current timestamp settings in the form of the structure described above. .It Dv NGM_SOURCE_SET_COUNTER Pq Ic setcounter This message specifies that a counter should be embedded in transmitted packets. Up to four counters may be independently configured. This message requires a structure containing the following fields: .Bl -tag -width ".Va increment" .It Va offset The offset from the beginning of the packet at which the counter is to be inserted. .It Va flags Set to 1 to enable the counter. .It Va width The byte width of the counter. It may be 1, 2, or 4. .It Va next_val The value for the next insertion of the counter. .It Va min_val The minimum value to be used by the counter. .It Va max_val The maximum value to be used by the counter. .It Va increment The value to be added to the counter after each insertion. It may be negative. .It Va index The counter to be configured, from 0 to 3. .El .It Dv NGM_SOURCE_GET_COUNTER Pq Ic getcounter This message requires a single .Vt uint8_t parameter which specifies the counter to query. Returns the current counter settings in the form of the structure described above. .El .Sh SHUTDOWN This node shuts down upon receipt of a .Dv NGM_SHUTDOWN control message, when all hooks have been disconnected, or when the .Va output hook has been disconnected. .Sh EXAMPLES Attach the node to an .Xr ng_ether 4 node for an interface. If .Nm ng_ether is not already loaded you will need to do so. For example, these commands load the .Nm ng_ether module and attach the .Va output hook of a new .Nm source node to .Va orphans hook of the .Li bge0: .Nm ng_ether node. .Bd -literal -offset indent kldload ng_ether ngctl mkpeer bge0: source orphans output .Ed .Pp At this point the new node can be referred to as .Dq Li bge0:orphans . The node can be given its own name like this: .Pp .Dl "ngctl name bge0:orphans src0" .Pp After which it can be referred to as .Dq Li src0: . .Pp Once created, packets can be sent to the node as raw binary data. Each packet must be delivered in a separate netgraph message. .Pp The following example uses a short Perl script to convert the hex representation of an ICMP packet to binary and deliver it to the .Nm source node's .Va input hook via .Xr nghook 8 : .Bd -literal -offset indent perl -pe 's/(..)[ \et\en]*/chr(hex($1))/ge' <