From 33ee29e03e1abf10ee5653e77acee5f25adc2b26 Mon Sep 17 00:00:00 2001 From: brueffer Date: Mon, 10 Apr 2006 20:12:17 +0000 Subject: - Correct some typos - New sentence, new line --- share/man/man4/bce.4 | 20 ++++++++++++-------- 1 file changed, 12 insertions(+), 8 deletions(-) (limited to 'share/man/man4/bce.4') diff --git a/share/man/man4/bce.4 b/share/man/man4/bce.4 index 67a3157..cb2667b 100644 --- a/share/man/man4/bce.4 +++ b/share/man/man4/bce.4 @@ -57,8 +57,9 @@ BCM5706 and BCM5708 Ethernet controllers. .Pp The NetXtreme II product family is composed of various Converged NIC (or CNIC) Ethernet controllers which support a TCP Offload Engine (TOE), Remote DMA (RDMA), -and iSCSI acceleration, in addtion to standard L2 Ethernet traffic, all on the -same controller. The following features are supported in the +and iSCSI acceleration, in addition to standard L2 Ethernet traffic, all on the +same controller. +The following features are supported in the .Nm driver under FreeBSD: .Bd -literal -offset indent @@ -122,7 +123,7 @@ For more information on configuring this device, see The .Nm driver provides support for various NICs based on the Broadcom NetXtreme II -family of Gigabit Ethernet controller, including the +family of Gigabit Ethernet controllers, including the following: .Pp .Bl -bullet -compact @@ -225,13 +226,15 @@ The driver could not map the RX mbuf memory into the controller's DMA address space. .It "bce%d: Firmware synchronization timeout!" The driver was not able to synchronize with the firmware running on the -controller. The firmware may be stopped or hung. +controller. +The firmware may be stopped or hung. .It "bce%d: Invalid Ethernet address!" The driver was not able to read a vaild Ethernet MAC address from NVRAM. .It "bce%d: Reset failed!" The driver has encountered a fatal initialization error. .It "bce%d: Byte swap is incorrect!" -The driver has encountered a fatal initialization error. Contact the author +The driver has encountered a fatal initialization error. +Contact the author with details of the CPU architecture and system chipset in use. .It "bce%d: Firmware did not complete initialization!" The driver has encountered a fatal initialization error. @@ -241,7 +244,8 @@ The driver has encountered a fatal initialization error. The driver could not map a RX mbuf into DMA addressable memory. .It "bce%d: Error filling RX chain: rx_bd[0x%04X]!" The driver was unable to allocate enough mbufs to fill the RX chain -during initialization. Try increasing the number of mbufs available in +during initialization. +Try increasing the number of mbufs available in the system, increase system memory, or if using jumbo frames, make sure enough 9KB mbufs are available. .It "bce%d: Failed to allocate new mbuf, incoming frame dropped!" @@ -270,8 +274,8 @@ Disabling VLAN tag stripping is not currently supported by the driver. The device has stopped responding to the network, there is a problem with the cable connection, or a driver logic problem has occurred.. .It "bce%d: Fatal attention detected: 0x%08X!" -A controller hardware failure has occurred. If the problem continues replace -the controller. +A controller hardware failure has occurred. +If the problem continues replace the controller. .El .Sh SEE ALSO .Xr arp 4 , -- cgit v1.1