From 3342c80c8fb09cce70131f496174f58caa2279e8 Mon Sep 17 00:00:00 2001 From: pjd Date: Thu, 9 Dec 2004 12:26:47 +0000 Subject: - Turn off 'fast' mode by default and increase maximum memory to consume when this mode is used. - Manual page update. --- sbin/geom/class/stripe/gstripe.8 | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'sbin') diff --git a/sbin/geom/class/stripe/gstripe.8 b/sbin/geom/class/stripe/gstripe.8 index df1b84e..bb9eed4 100644 --- a/sbin/geom/class/stripe/gstripe.8 +++ b/sbin/geom/class/stripe/gstripe.8 @@ -169,7 +169,7 @@ GEOM class. This can be set to a number between 0 and 3 inclusive. If set to 0 minimal debug information is printed, and if set to 3 the maximum amount of debug information in printed. -.It Va kern.geom.stripe.fast : No 1 +.It Va kern.geom.stripe.fast : No 0 If set to a non-zero value enable .Dq "fast mode" instead of the normal @@ -182,7 +182,7 @@ If enough memory cannot be allocated, .Nm STRIPE will fall back to .Dq "economic mode" . -.It Va kern.geom.stripe.maxmem : No 1310720 +.It Va kern.geom.stripe.maxmem : No 13107200 Maximum amount of memory that can be consumed by .Dq "fast mode" (in bytes). @@ -204,7 +204,7 @@ The following example shows how to set up a striped device from four disks with create a file system on it, and mount it: .Bd -literal -offset indent -gstripe label -v -s 4096 data /dev/da0 /dev/da1 /dev/da2 /dev/da3 +gstripe label -v -s 131072 data /dev/da0 /dev/da1 /dev/da2 /dev/da3 newfs /dev/stripe/data mount /dev/stripe/data /mnt [...] -- cgit v1.1