diff options
Diffstat (limited to 'sys/dev/e1000/e1000_ich8lan.h')
| -rw-r--r-- | sys/dev/e1000/e1000_ich8lan.h | 32 |
1 files changed, 26 insertions, 6 deletions
diff --git a/sys/dev/e1000/e1000_ich8lan.h b/sys/dev/e1000/e1000_ich8lan.h index 9cb79c0..edc1dd1 100644 --- a/sys/dev/e1000/e1000_ich8lan.h +++ b/sys/dev/e1000/e1000_ich8lan.h @@ -107,9 +107,23 @@ #define E1000_FEXTNVM6_REQ_PLL_CLK 0x00000100 #define E1000_FEXTNVM6_ENABLE_K1_ENTRY_CONDITION 0x00000200 - +#define E1000_FEXTNVM6_K1_OFF_ENABLE 0x80000000 +/* bit for disabling packet buffer read */ +#define E1000_FEXTNVM7_DISABLE_PB_READ 0x00040000 +#define E1000_FEXTNVM7_SIDE_CLK_UNGATE 0x00000004 #define E1000_FEXTNVM7_DISABLE_SMB_PERST 0x00000020 - +#define E1000_FEXTNVM9_IOSFSB_CLKGATE_DIS 0x00000800 +#define E1000_FEXTNVM9_IOSFSB_CLKREQ_DIS 0x00001000 +#define E1000_FEXTNVM11_DISABLE_PB_READ 0x00000200 +#define E1000_FEXTNVM11_DISABLE_MULR_FIX 0x00002000 + +/* bit24: RXDCTL thresholds granularity: 0 - cache lines, 1 - descriptors */ +#define E1000_RXDCTL_THRESH_UNIT_DESC 0x01000000 + +#define NVM_SIZE_MULTIPLIER 4096 /*multiplier for NVMS field*/ +#define E1000_FLASH_BASE_ADDR 0xE000 /*offset of NVM access regs*/ +#define E1000_CTRL_EXT_NVMVS 0x3 /*NVM valid sector */ +#define E1000_TARC0_CB_MULTIQ_3_REQ (1 << 28 | 1 << 29) #define PCIE_ICH8_SNOOP_ALL PCIE_NO_SNOOP_ALL #define E1000_ICH_RAR_ENTRIES 7 @@ -171,6 +185,8 @@ #define E1000_NVM_K1_CONFIG 0x1B /* NVM K1 Config Word */ #define E1000_NVM_K1_ENABLE 0x1 /* NVM Enable K1 bit */ +#define K1_ENTRY_LATENCY 0 +#define K1_MIN_TIME 1 /* SMBus Control Phy Register */ #define CV_SMB_CTRL PHY_REG(769, 23) @@ -184,6 +200,10 @@ #define I218_ULP_CONFIG1_INBAND_EXIT 0x0020 /* Inband on ULP exit */ #define I218_ULP_CONFIG1_WOL_HOST 0x0040 /* WoL Host on ULP exit */ #define I218_ULP_CONFIG1_RESET_TO_SMBUS 0x0100 /* Reset to SMBus mode */ +/* enable ULP even if when phy powered down via lanphypc */ +#define I218_ULP_CONFIG1_EN_ULP_LANPHYPC 0x0400 +/* disable clear of sticky ULP on PERST */ +#define I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST 0x0800 #define I218_ULP_CONFIG1_DISABLE_SMB_PERST 0x1000 /* Disable on PERST# */ /* SMBus Address Phy Register */ @@ -222,6 +242,9 @@ #define HV_PM_CTRL_PLL_STOP_IN_K1_GIGA 0x100 #define HV_PM_CTRL_K1_ENABLE 0x4000 +#define I217_PLL_CLOCK_GATE_REG PHY_REG(772, 28) +#define I217_PLL_CLOCK_GATE_MASK 0x07FF + #define SW_FLAG_TIMEOUT 1000 /* SW Semaphore flag timeout in ms */ /* Inband Control */ @@ -302,15 +325,12 @@ #define E1000_SVCR_OFF_TIMER_SHIFT 16 #define E1000_SVT_OFF_HWM_MASK 0x0000001F -#if defined(QV_RELEASE) || !defined(NO_PCH_LPT_B0_SUPPORT) -#define E1000_PCI_REVISION_ID_REG 0x08 -#endif /* defined(QV_RELEASE) || !defined(NO_PCH_LPT_B0_SUPPORT) */ void e1000_set_kmrn_lock_loss_workaround_ich8lan(struct e1000_hw *hw, bool state); void e1000_igp3_phy_powerdown_workaround_ich8lan(struct e1000_hw *hw); void e1000_gig_downshift_workaround_ich8lan(struct e1000_hw *hw); void e1000_suspend_workarounds_ich8lan(struct e1000_hw *hw); -void e1000_resume_workarounds_pchlan(struct e1000_hw *hw); +u32 e1000_resume_workarounds_pchlan(struct e1000_hw *hw); s32 e1000_configure_k1_ich8lan(struct e1000_hw *hw, bool k1_enable); void e1000_copy_rx_addrs_to_phy_ich8lan(struct e1000_hw *hw); s32 e1000_lv_jumbo_workaround_ich8lan(struct e1000_hw *hw, bool enable); |
