diff options
Diffstat (limited to 'sys/contrib/dev/ath/ah_soc.h')
| -rw-r--r-- | sys/contrib/dev/ath/ah_soc.h | 110 |
1 files changed, 110 insertions, 0 deletions
diff --git a/sys/contrib/dev/ath/ah_soc.h b/sys/contrib/dev/ath/ah_soc.h new file mode 100644 index 0000000..0852bd3 --- /dev/null +++ b/sys/contrib/dev/ath/ah_soc.h @@ -0,0 +1,110 @@ +/*- + * Copyright (c) 2006 Sam Leffler, Errno Consulting, Atheros + * Communications, Inc. All rights reserved. + * + * Redistribution and use in source and binary forms are permitted + * provided that the following conditions are met: + * 1. The materials contained herein are unmodified and are used + * unmodified. + * 2. Redistributions of source code must retain the above copyright + * notice, this list of conditions and the following NO + * ''WARRANTY'' disclaimer below (''Disclaimer''), without + * modification. + * 3. Redistributions in binary form must reproduce at minimum a + * disclaimer similar to the Disclaimer below and any redistribution + * must be conditioned upon including a substantially similar + * Disclaimer requirement for further binary redistribution. + * 4. Neither the names of the above-listed copyright holders nor the + * names of any contributors may be used to endorse or promote + * product derived from this software without specific prior written + * permission. + * + * NO WARRANTY + * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS + * ''AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT + * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, + * MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. + * IN NO EVENT SHALL THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE + * FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT + * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF + * USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND + * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, + * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT + * OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF + * SUCH DAMAGES. + * + * $Id: //depot/sw/branches/sam_hal/ah_soc.h#3 $ + */ +#ifndef _ATH_AH_SOC_H_ +#define _ATH_AH_SOC_H_ +/* + * Atheros System on Chip (SoC) public definitions. + */ + +/* + * This is board-specific data that is stored in a "known" + * location in flash. To find the start of this data search + * back from the (aliased) end of flash by 0x1000 bytes at a + * time until you find the string "5311", which marks the + * start of Board Configuration. Typically one gives up if + * more than 500KB is searched. + */ +struct ar531x_boarddata { + u_int32_t magic; /* board data is valid */ +#define AR531X_BD_MAGIC 0x35333131 /* "5311", for all 531x platforms */ + u_int16_t cksum; /* checksum (starting with BD_REV 2) */ + u_int16_t rev; /* revision of this struct */ +#define BD_REV 4 + char boardName[64]; /* Name of board */ + u_int16_t major; /* Board major number */ + u_int16_t minor; /* Board minor number */ + u_int32_t config; /* Board configuration */ +#define BD_ENET0 0x00000001 /* ENET0 is stuffed */ +#define BD_ENET1 0x00000002 /* ENET1 is stuffed */ +#define BD_UART1 0x00000004 /* UART1 is stuffed */ +#define BD_UART0 0x00000008 /* UART0 is stuffed (dma) */ +#define BD_RSTFACTORY 0x00000010 /* Reset factory defaults stuffed */ +#define BD_SYSLED 0x00000020 /* System LED stuffed */ +#define BD_EXTUARTCLK 0x00000040 /* External UART clock */ +#define BD_CPUFREQ 0x00000080 /* cpu freq is valid in nvram */ +#define BD_SYSFREQ 0x00000100 /* sys freq is set in nvram */ +#define BD_WLAN0 0x00000200 /* Enable WLAN0 */ +#define BD_MEMCAP 0x00000400 /* CAP SDRAM @ memCap for testing */ +#define BD_DISWATCHDOG 0x00000800 /* disable system watchdog */ +#define BD_WLAN1 0x00001000 /* Enable WLAN1 (ar5212) */ +#define BD_ISCASPER 0x00002000 /* FLAG for AR2312 */ +#define BD_WLAN0_2G_EN 0x00004000 /* FLAG for radio0_2G */ +#define BD_WLAN0_5G_EN 0x00008000 /* FLAG for radio0_2G */ +#define BD_WLAN1_2G_EN 0x00020000 /* FLAG for radio0_2G */ +#define BD_WLAN1_5G_EN 0x00040000 /* FLAG for radio0_2G */ + u_int16_t resetConfigGpio; /* Reset factory GPIO pin */ + u_int16_t sysLedGpio; /* System LED GPIO pin */ + + u_int32_t cpuFreq; /* CPU core frequency in Hz */ + u_int32_t sysFreq; /* System frequency in Hz */ + u_int32_t cntFreq; /* Calculated C0_COUNT frequency */ + + u_int8_t wlan0Mac[6]; + u_int8_t enet0Mac[6]; + u_int8_t enet1Mac[6]; + + u_int16_t pciId; /* Pseudo PCIID for common code */ + u_int16_t memCap; /* cap bank1 in MB */ + + /* version 3 */ + u_int8_t wlan1Mac[6]; /* (ar5212) */ +}; + +/* + * Board support data. The driver is required to locate + * and fill-in this information before passing a reference to + * this structure as the HAL_BUS_TAG parameter supplied to + * ath_hal_attach. + */ +struct ar531x_config { + const struct ar531x_boarddata *board; /* board config data */ + const char *radio; /* radio config data */ + int unit; /* unit number [0, 1] */ + void *tag; /* bus space tag */ +}; +#endif /* _ATH_AH_SOC_H_ */ |
