5 files changed, 0 insertions, 164 deletions
diff --git a/share/man/man4/Makefile b/share/man/man4/Makefile
index 49691f3..962caf8 100644
--- a/share/man/man4/Makefile
+++ b/share/man/man4/Makefile
@@ -32,7 +32,6 @@ MAN=	aac.4 \
 	audit.4 \
 	auditpipe.4 \
 	aue.4 \
-	awi.4 \
 	axe.4 \
 	bce.4 \
 	bfe.4 \
@@ -436,7 +435,6 @@ MLINKS+=ata.4 acd.4 \
 	ata.4 afd.4 \
 	ata.4 ast.4
 MLINKS+=aue.4 if_aue.4
-MLINKS+=awi.4 if_awi.4
 MLINKS+=axe.4 if_axe.4
 MLINKS+=bce.4 if_bce.4
 MLINKS+=bfe.4 if_bfe.4
diff --git a/share/man/man4/altq.4 b/share/man/man4/altq.4
index bc807d3..7fd6ec1 100644
--- a/share/man/man4/altq.4
+++ b/share/man/man4/altq.4
@@ -118,7 +118,6 @@ They have been applied to the following hardware drivers:
 .Xr an 4 ,
 .Xr ath 4 ,
 .Xr aue 4 ,
-.Xr awi 4 ,
 .Xt axe 4 ,
 .Xr bce 4 ,
 .Xr bfe 4 ,
diff --git a/share/man/man4/awi.4 b/share/man/man4/awi.4
deleted file mode 100644
index 02fd216..0000000
--- a/share/man/man4/awi.4
+++ /dev/null
@@ -1,155 +0,0 @@
-.\"     $NetBSD: awi.4,v 1.6 2000/03/22 11:24:33 onoe Exp $
-.\" $FreeBSD$
-.\"
-.Dd July 16, 2005
-.Dt AWI 4
-.Os
-.Sh NAME
-.Nm awi
-.Nd "AMD PCnetMobile IEEE 802.11 PCMCIA wireless network driver"
-.Sh SYNOPSIS
-To compile this driver into the kernel,
-place the following lines in your
-kernel configuration file:
-.Bd -ragged -offset indent
-.Cd "device awi"
-.Cd "device wlan"
-.Ed
-.Pp
-Alternatively, to load the driver as a
-module at boot time, place the following line in
-.Xr loader.conf 5 :
-.Bd -literal -offset indent
-if_awi_load="YES"
-.Ed
-.Sh DESCRIPTION
-The
-.Nm
-driver supports various IEEE 802.11 wireless cards
-which run AMD PCnetMobile firmware based on AMD 79c930 controller
-with Intersil (formerly Harris) PRISM radio chipset.
-It provides access to 32kb of memory shared between the controller
-and the host.
-All host/device interaction is via this shared memory, which can be
-accessed either via PCMCIA memory space or I/O space.
-The
-.Nm
-driver encapsulates all IP and ARP traffic as 802.11 frames.
-.Pp
-The driver works both in infrastructure mode and in adhoc (independent
-BSS) mode.
-.Pp
-In infrastructure mode, it communicates with an Access Point
-which serves as a link-layer bridge between an Ethernet and
-the wireless network.
-An access point also provides roaming capability
-which allows wireless nodes to move between access points.
-.Pp
-In adhoc mode, it communicates peer to peer.
-Though it is more efficient to communicate between wireless nodes,
-the coverage is limited spatially due to lack of roaming capability.
-.Pp
-In addition to these two modes in the IEEE 802.11 specification, the
-.Nm
-driver also supports a variant of adhoc mode out of spec for DS radio cards,
-which makes it possible to communicate with adhoc mode of
-.Xr wi 4
-driver.
-The NWID does not affect in this mode.
-.Pp
-For more information on configuring this device, see
-.Xr ifconfig 8 .
-.Sh HARDWARE
-Cards supported by the
-.Nm
-driver include:
-.Pp
-.Bl -tag -width BayStack_650x -offset indent
-.It BayStack 650
-1Mbps Frequency Hopping PCCARD adapter
-.It BayStack 660
-2Mbps Direct Sequence PCCARD adapter
-.It Icom SL-200
-2Mbps Direct Sequence PCCARD adapter
-.It Melco WLI-PCM
-2Mbps Direct Sequence PCCARD adapter
-.It NEL SSMagic
-2Mbps Direct Sequence PCCARD adapter
-.It Netwave AirSurfer Plus
-1Mbps Frequency Hopping PCCARD adapter
-.It Netwave AirSurfer Pro
-2Mbps Direct Sequence PCCARD adapter
-.It Nokia C020 WLAN
-2Mbps Direct Sequence PCCARD adapter
-.It Farallon SkyLINE
-2Mbps Direct Sequence PCCARD adapter
-.El
-.Pp
-The original Xircom Netwave AirSurfer is supported by the
-.Xr cnw 4
-driver.
-.Sh MEDIA SELECTION
-The DS cards support
-.Em DS1
-and
-.Em DS2
-media types, while the FH cards support
-.Em FH1
-media type.
-For each media type,
-.Em adhoc
-mediaopt can be used to indicate the driver to operate in adhoc mode.
-For DS radio cards,
-.Em adhoc , Ns Em flag0
-mediaopt can be used for
-.Xr wi 4
-compatible adhoc mode.
-In addition to these station modes,
-.Em hostap
-mediaopt can be used to create a host-based access point.
-.Sh DIAGNOSTICS
-.Bl -diag
-.It "awi0: awi_pccard_probe: bad banner:"
-The device failed to initialize its firmware.
-.It "awi0: failed to complete selftest (%s)"
-The device failed to complete its self test.
-In some circumstances, resetting device after power on fails.
-Re-inserting the card or down-then-up interface may be helpful.
-.It "awi0: transmit timeout"
-The device failed to generate an interrupt to acknowledge a
-transmitted packet.
-.It "awi0: failed to lock interrupt"
-The system was unable to obtain the lock to access shared memory.
-.It "awi0: command %d failed %x"
-The device failed to complete the request from the system.
-.El
-.Sh SEE ALSO
-.Xr altq 4 ,
-.Xr arp 4 ,
-.Xr cnw 4 ,
-.Xr miibus 4 ,
-.Xr netintro 4 ,
-.Xr pccard 4 ,
-.Xr wi 4 ,
-.Xr wlan 4 ,
-.Xr ifconfig 8
-.Rs
-.%T Am79C930 PCnet Mobile Single-Chip Wireless LAN Media Access Controller
-.%O http://www.amd.com
-.Re
-.Sh HISTORY
-The
-.Nm
-device driver first appeared in
-.Nx 1.5 .
-.Sh AUTHORS
-.An -nosplit
-The initial version of the
-.Nm
-driver was written by
-.An Bill Sommerfeld Aq sommerfeld@netbsd.org .
-Then the
-.Nm
-driver module was completely rewritten to support cards with DS phy and
-to support adhoc mode by
-.An Atsushi Onoe Aq onoe@netbsd.org .
diff --git a/share/man/man4/cnw.4 b/share/man/man4/cnw.4
index c15312b..91f5a12 100644
--- a/share/man/man4/cnw.4
+++ b/share/man/man4/cnw.4
@@ -56,9 +56,6 @@ Note that the driver does not support newer devices
 such as the Netwave AirSurfer
 .Dq Plus ,
 or the BayStack 650/660.
-These devices are supported by the
-.Xr awi 4
-driver.
 .Pp
 Netwave devices are not compatible with IEEE 802.11 wireless networks.
 Also note that there are Netwave devices with different wireless frequency,
@@ -106,7 +103,6 @@ and increase memory available to the PC Card controller.
 .El
 .Sh SEE ALSO
 .Xr arp 4 ,
-.Xr awi 4 ,
 .Xr inet 4 ,
 .Xr intro 4 ,
 .Xr pccard 4
diff --git a/share/man/man4/wlan.4 b/share/man/man4/wlan.4
index 8440592..d636395 100644
--- a/share/man/man4/wlan.4
+++ b/share/man/man4/wlan.4
@@ -44,7 +44,6 @@ The
 is required for the
 .Xr an 4 ,
 .Xr ath 4 ,
-.Xr awi 4 ,
 .Xr ipw 4 ,
 .Xr iwi 4 ,
 .Xr ral 4 ,
@@ -123,7 +122,6 @@ was used to be compatible with
 .Sh SEE ALSO
 .Xr an 4 ,
 .Xr ath 4 ,
-.Xr awi 4 ,
 .Xr ipw 4 ,
 .Xr iwi 4 ,
 .Xr netintro 4 ,