diff options
Diffstat (limited to 'sbin/ifconfig/ifconfig.8')
-rw-r--r-- | sbin/ifconfig/ifconfig.8 | 26 |
1 files changed, 13 insertions, 13 deletions
diff --git a/sbin/ifconfig/ifconfig.8 b/sbin/ifconfig/ifconfig.8 index e3f49f9..eed4c59 100644 --- a/sbin/ifconfig/ifconfig.8 +++ b/sbin/ifconfig/ifconfig.8 @@ -675,7 +675,7 @@ and DAD will be performed when this flag is cleared. .It Cm -ifdisabled Clear a flag .Cm ifdisabled . -When this flag is cleared and +When this flag is cleared and .Cm auto_linklocal flag is enabled, automatic configuration of a link-local address is performed. @@ -706,7 +706,7 @@ Specify the operating mode for this cloned device. .Ar mode is one of .Cm sta , -.Cm ahdemo +.Cm ahdemo (or .Cm adhoc-demo ), .Cm ibss , @@ -744,7 +744,7 @@ the device (if supported). Mark a .Cm wds device as operating in ``legacy mode''. -Legacy +Legacy .Cm wds devices have a fixed peer relationship and do not, for example, roam if their peer stops communicating. @@ -760,9 +760,9 @@ Mark the cloned interface as depending on hardware support to track received beacons. To have beacons tracked in software use .Fl beacons . -For +For .Cm hostap -mode +mode .Fl beacons can also be used to indicate no beacons should be transmitted; this can be useful when creating a WDS configuration but @@ -897,7 +897,7 @@ The .Ar interval parameter is specified in seconds. By default a background scan is considered every 300 seconds (5 minutes). -The +The .Ar interval may not be set to less than 15 seconds. .It Cm bintval Ar interval @@ -998,19 +998,19 @@ and .Cm t (Atheros Dynamic Turbo mode, or appended to ``st'' and ``dt''). The full set of channel widths following a '/' are: -.Cm 5 +.Cm 5 (5MHz aka quarter-rate channel), -.Cm 10 +.Cm 10 (10MHz aka half-rate channel), -.Cm 20 +.Cm 20 (20MHz mostly for use in specifying ht20), and -.Cm 40 +.Cm 40 (40MHz mostly for use in specifying ht40). In addition, a 40MHz HT channel specification may include the location of the extension channel by appending ``+'' or ``-'' for above and below, -respectively; e.g. ``2437:ht/40+'' specifies 40MHz wide HT operation +respectively; e.g. ``2437:ht/40+'' specifies 40MHz wide HT operation with the center channel at frequency 2437 and the extension channel above. .It Cm country Ar name Set the country code to use in calculating the regulatory constraints @@ -2021,7 +2021,7 @@ Nodes on the mesh without a path to this root mesh station with try to discover a path to us. .El By default -.Cm hwmprootmode +.Cm hwmprootmode is set to .Ar DISABLED . .It Cm hwmpmaxhops Ar cnt @@ -2569,7 +2569,7 @@ For example, the values of 802.11 WEP keys and passphrases will be printed, if accessible to the current user. This information is not printed by default, as it may be considered sensitive. -.Pp +.Pp If the network interface driver is not present in the kernel then .Nm will attempt to load it. |