diff options
Diffstat (limited to 'contrib/tcpdump/ieee802_11_radio.h')
-rw-r--r-- | contrib/tcpdump/ieee802_11_radio.h | 55 |
1 files changed, 45 insertions, 10 deletions
diff --git a/contrib/tcpdump/ieee802_11_radio.h b/contrib/tcpdump/ieee802_11_radio.h index c56be01..a2b2f16 100644 --- a/contrib/tcpdump/ieee802_11_radio.h +++ b/contrib/tcpdump/ieee802_11_radio.h @@ -53,7 +53,11 @@ #endif #endif /* _KERNEL */ -/* The radio capture header precedes the 802.11 header. */ +/* + * The radio capture header precedes the 802.11 header. + * + * Note well: all radiotap fields are little-endian. + */ struct ieee80211_radiotap_header { u_int8_t it_version; /* Version 0. Only increases * for drastic changes, @@ -87,15 +91,19 @@ struct ieee80211_radiotap_header { * IEEE80211_RADIOTAP_CHANNEL 2 x u_int16_t MHz, bitmap * * Tx/Rx frequency in MHz, followed by flags (see below). + * Note that IEEE80211_RADIOTAP_XCHANNEL must be used to + * represent an HT channel as there is not enough room in + * the flags word. * * IEEE80211_RADIOTAP_FHSS u_int16_t see below * * For frequency-hopping radios, the hop set (first byte) * and pattern (second byte). * - * IEEE80211_RADIOTAP_RATE u_int8_t 500kb/s + * IEEE80211_RADIOTAP_RATE u_int8_t 500kb/s or index * - * Tx/Rx data rate + * Tx/Rx data rate. If bit 0x80 is set then it represents an + * an MCS index and not an IEEE rate. * * IEEE80211_RADIOTAP_DBM_ANTSIGNAL int8_t decibels from * one milliwatt (dBm) @@ -154,6 +162,17 @@ struct ieee80211_radiotap_header { * * Unitless indication of the Rx/Tx antenna for this packet. * The first antenna is antenna 0. + * + * IEEE80211_RADIOTAP_XCHANNEL u_int32_t bitmap + * u_int16_t MHz + * u_int8_t channel number + * u_int8_t .5 dBm + * + * Extended channel specification: flags (see below) followed by + * frequency in MHz, the corresponding IEEE channel number, and + * finally the maximum regulatory transmit power cap in .5 dBm + * units. This property supersedes IEEE80211_RADIOTAP_CHANNEL + * and only one of the two should be present. */ enum ieee80211_radiotap_type { IEEE80211_RADIOTAP_TSFT = 0, @@ -170,17 +189,27 @@ enum ieee80211_radiotap_type { IEEE80211_RADIOTAP_ANTENNA = 11, IEEE80211_RADIOTAP_DB_ANTSIGNAL = 12, IEEE80211_RADIOTAP_DB_ANTNOISE = 13, + IEEE80211_RADIOTAP_XCHANNEL = 14, IEEE80211_RADIOTAP_EXT = 31 }; #ifndef _KERNEL -/* Channel flags. */ -#define IEEE80211_CHAN_TURBO 0x0010 /* Turbo channel */ -#define IEEE80211_CHAN_CCK 0x0020 /* CCK channel */ -#define IEEE80211_CHAN_OFDM 0x0040 /* OFDM channel */ -#define IEEE80211_CHAN_2GHZ 0x0080 /* 2 GHz spectrum channel. */ -#define IEEE80211_CHAN_5GHZ 0x0100 /* 5 GHz spectrum channel */ -#define IEEE80211_CHAN_PASSIVE 0x0200 /* Only passive scan allowed */ +/* Channel flags; some are used only with XCHANNEL */ +#define IEEE80211_CHAN_TURBO 0x00010 /* Turbo channel */ +#define IEEE80211_CHAN_CCK 0x00020 /* CCK channel */ +#define IEEE80211_CHAN_OFDM 0x00040 /* OFDM channel */ +#define IEEE80211_CHAN_2GHZ 0x00080 /* 2 GHz spectrum channel. */ +#define IEEE80211_CHAN_5GHZ 0x00100 /* 5 GHz spectrum channel */ +#define IEEE80211_CHAN_PASSIVE 0x00200 /* Only passive scan allowed */ +#define IEEE80211_CHAN_DYN 0x00400 /* Dynamic CCK-OFDM channel */ +#define IEEE80211_CHAN_GFSK 0x00800 /* GFSK channel (FHSS PHY) */ +#define IEEE80211_CHAN_GSM 0x01000 /* 900 MHz spectrum channel */ +#define IEEE80211_CHAN_STURBO 0x02000 /* 11a static turbo channel only */ +#define IEEE80211_CHAN_HALF 0x04000 /* Half rate channel */ +#define IEEE80211_CHAN_QUARTER 0x08000 /* Quarter rate channel */ +#define IEEE80211_CHAN_HT20 0x10000 /* HT 20 channel */ +#define IEEE80211_CHAN_HT40U 0x20000 /* HT 40 channel w/ ext above */ +#define IEEE80211_CHAN_HT40D 0x40000 /* HT 40 channel w/ ext below */ #endif /* !_KERNEL */ /* For IEEE80211_RADIOTAP_FLAGS */ @@ -197,5 +226,11 @@ enum ieee80211_radiotap_type { #define IEEE80211_RADIOTAP_F_FRAG 0x08 /* sent/received * with fragmentation */ +#define IEEE80211_RADIOTAP_F_FCS 0x10 /* frame includes FCS */ +#define IEEE80211_RADIOTAP_F_DATAPAD 0x20 /* frame has padding between + * 802.11 header and payload + * (to 32-bit boundary) + */ +#define IEEE80211_RADIOTAP_F_BADFCS 0x40 /* does not pass FCS check */ #endif /* _NET_IF_IEEE80211RADIOTAP_H_ */ |