diff options
-rw-r--r-- | sys/dev/ida/ida_disk.c | 6 | ||||
-rw-r--r-- | sys/dev/ida/idareg.h | 216 |
2 files changed, 188 insertions, 34 deletions
diff --git a/sys/dev/ida/ida_disk.c b/sys/dev/ida/ida_disk.c index 1a015f9..f554bac 100644 --- a/sys/dev/ida/ida_disk.c +++ b/sys/dev/ida/ida_disk.c @@ -190,9 +190,9 @@ idad_attach(device_t dev) return (ENXIO); } - drv->cylinders = dinfo.ncylinders; - drv->heads = dinfo.nheads; - drv->sectors = dinfo.nsectors; + drv->cylinders = dinfo.dp.ncylinders; + drv->heads = dinfo.dp.nheads; + drv->sectors = dinfo.dp.nsectors; drv->secsize = dinfo.secsize == 0 ? 512 : dinfo.secsize; drv->secperunit = dinfo.secperunit; diff --git a/sys/dev/ida/idareg.h b/sys/dev/ida/idareg.h index 41bd0ce..2317a3d 100644 --- a/sys/dev/ida/idareg.h +++ b/sys/dev/ida/idareg.h @@ -80,36 +80,47 @@ /* * return status codes */ -#define SOFT_ERROR 0x02 -#define HARD_ERROR 0x04 +#define SOFT_ERROR 0x02 /* Non-fatal error. */ +#define HARD_ERROR 0x04 /* Fatal error. */ +#define INVALID_ERROR 0x10 /* Invalid Request Block. */ #define CMD_REJECTED 0x14 /* * command types */ -#define CMD_GET_LOG_DRV_INFO 0x10 -#define CMD_GET_CTRL_INFO 0x11 -#define CMD_SENSE_DRV_STATUS 0x12 -#define CMD_START_RECOVERY 0x13 -#define CMD_GET_PHYS_DRV_INFO 0x15 -#define CMD_BLINK_DRV_LEDS 0x16 -#define CMD_SENSE_DRV_LEDS 0x17 -#define CMD_GET_LOG_DRV_EXT 0x18 -#define CMD_GET_CTRL_INFO 0x11 -#define CMD_READ 0x20 -#define CMD_WRITE 0x30 -#define CMD_WRITE_MEDIA 0x31 -#define CMD_GET_CONFIG 0x50 -#define CMD_SET_CONFIG 0x51 -#define CMD_START_FIRMWARE 0x99 /* for integrated RAID */ -#define CMD_FLUSH_CACHE 0xc2 +#define CMD_GET_LOG_DRV_INFO 0x10 /* Identify controller */ +#define CMD_GET_CTRL_INFO 0x11 /* Identify logical driver */ +#define CMD_SENSE_DRV_STATUS 0x12 /* Sense logical drive status */ +#define CMD_START_RECOVERY 0x13 /* Start recover */ +#define CMD_GET_PHYS_DRV_INFO 0x15 /* Identify physical drive */ +#define CMD_BLINK_DRV_LEDS 0x16 /* Blink drive tray LEDs */ +#define CMD_SENSE_DRV_LEDS 0x17 /* Sense Blinking drive tray LEDs */ +#define CMD_GET_LOG_DRV_EXT 0x18 /* Identify logical drive, Extended */ +#define CMD_READ 0x20 /* Read */ +#define CMD_WRITE 0x30 /* Write */ +#define CMD_WRITE_MEDIA 0x31 /* Write media */ +#define CMD_RESET_CTRL 0x40 /* Reset controller */ +#define CMD_GET_CONFIG 0x50 /* Sense configuration */ +#define CMD_SET_CONFIG 0x51 /* Set configuration */ +#define CMD_LABEL_LOG_DRV 0x57 /* Label logical drive */ +#define CMD_SET_SURFACE_DELAY 0x60 /* Set surface delay */ +#define CMD_SENSE_BUS_PARAMS 0x65 /* Sense bus parameters */ +#define CMD_SENSE_SUBSYS_INFO 0x66 /* Sense Subsystem Information */ +#define CMD_SENSE_SURFACE_ATS 0x70 /* Sense surface analysis task status */ +#define CMD_PASSTHROUGH 0x90 /* Pass-through operation */ +#define CMD_RESET_SCSI_DEV 0x94 /* Reset SCSI device */ +#define CMD_PAUSE_BG_ACT 0x98 /* Pause Background Activity */ +#define CMD_RESUME_BG_ACT 0x99 /* Resume Background Activity */ +#define CMD_START_FIRMWARE 0x99 /* for integrated RAID */ +#define CMD_SENSE_DRV_ERR_LOG 0xa6 /* Sense drive error log */ +#define CMD_START_CPM 0xa7 /* Start controller performance monitoring */ +#define CMD_SENSE_CP 0xa8 /* Sense controller performance */ +#define CMD_STOP_CPM 0xa9 /* Stop controller performance monitoring */ +#define CMD_FLUSH_CACHE 0xc2 /* Flush/disable write cache */ +#define CMD_ACCEPT_MEDIA_EXCH 0xe0 /* Accept Media Exchange */ -/* - * command structures - */ -struct ida_drive_info { - u_int16_t secsize; - u_int32_t secperunit; +/* logical drive parameter table */ +struct ida_drive_param { u_int16_t ncylinders; u_int8_t nheads; u_int8_t signature; @@ -122,23 +133,97 @@ struct ida_drive_info { u_int16_t landing_zone; u_int8_t nsectors; u_int8_t checksum; - u_int8_t mirror; } __packed; -struct ida_controller_info { - u_int8_t num_drvs; - u_int32_t signature; - u_int8_t firm_rev[4]; +#define IDA_RAID0 0 /* No fault tolerance. */ +#define IDA_RAID4 1 /* Data Guard */ +#define IDA_RAID1 2 /* Mirroring */ +#define IDA_RAID5 3 /* Distributed Data Guard */ + +/* + * CMD_GET_LOG_DRV_INFO (0x10) + * Identify Logical Drive + */ +struct ida_drive_info { + u_int16_t secsize; /* block size in bytes */ + u_int32_t secperunit; /* blocks available */ + struct ida_drive_param dp; /* logical drive parameter table */ + u_int8_t mirror; /* fault tolerance */ + u_int8_t reserved; + u_int8_t bios_disable; } __packed; +/* + * CMD_GET_LOG_DRV_EXT (0x18) + * Identify Logical Drive, Extended + */ +struct ida_drive_info_ext { + u_int16_t secsize; /* block size in bytes */ + u_int32_t secperunit; /* blocks available */ + struct ida_drive_param dp; /* logical drive parameter table */ + u_int8_t mirror; /* fault tolerance */ + u_int8_t reserved; + u_int8_t bios_disable; + u_int32_t ld_id; /* Logical drive identifier */ + u_int8_t ld_label[64]; /* Logical drive label */ +} __packed; + +/* + * CMD_GET_CTRL_INFO (0x11) + * Identify Controller + */ +struct ida_controller_info { + u_int8_t num_drvs; /* Number of configured logical drives */ + u_int32_t signature; /* Configuration signature */ + u_int8_t firm_rev[4]; /* ASCII firmware revision */ + u_int8_t rom_rev[4]; /* ROM firmware revision */ + u_int8_t hw_rev; /* Revision level of the hardware */ + u_int32_t bb_rev; + u_int32_t dp_map; /* Drive present bit map */ + u_int32_t ed_map; /* External drive bit map */ + u_int32_t board_id; + u_int8_t cfg_error; + u_int32_t nd_map; /* Non-disk map */ + u_int8_t bad_ram_addr; + u_int8_t cpu_rev; + u_int8_t pdpi_rev; + u_int8_t epic_rev; + u_int8_t wcxc_rev; + u_int8_t mkt_rev; /* Marketing revision */ + u_int8_t cflag; /* Controller flags */ +#define IDA_CI_CFLAG_7DPB (1<<3) +#define IDA_CI_CFLAG_BIGMAP (1<<7) + u_int8_t hflag; + u_int8_t expand_dis; + u_int8_t scsi_cc; /* SCSI chip count */ + u_int32_t max_req_blocks; + u_int32_t cclock; /* Controller Clock */ + u_int8_t dp_scsi; /* Drives per SCSI bus */ + u_int16_t big_dp_map[8]; /* Big drive present bit map */ + u_int16_t big_ed_map[8]; /* Big external drive bit map */ + u_int16_t big_nd_map[8]; /* Big non-disk map */ + u_int16_t task_flags; + u_int8_t icl_bus; + u_int8_t red_modes; + u_int8_t cur_red_mode; + u_int8_t red_ctlr_stat; + u_int8_t red_fail_reason; + u_int8_t reserved[403]; +} __packed; +/* + * CMD_SENSE_DRV_STATUS (0x12) + * Sense logical drive status + */ struct ida_drive_status { u_int8_t status; u_int32_t failure_map; - u_int8_t reserved[416]; + u_int16_t read_err[32]; + u_int16_t write_error[32]; + u_int8_t reserved0[288]; u_int32_t secrecover; u_int8_t rebuilding; - u_int16_t remap_cnt[8]; + u_int16_t remap_cnt[32]; u_int32_t repl_map; u_int32_t spare_map; u_int8_t spare_status; @@ -155,4 +240,73 @@ struct ida_drive_status { u_int8_t big_spare_repl_map[128]; u_int16_t big_repl_ok_map[8]; u_int8_t big_rebuilding; + u_int8_t reserved1[36]; +} __packed; + +/* + * CMD_GET_PHYS_DRV_INFO (0x15) + * Identify Physical Drive + */ +struct ida_phys_drv_info { + u_int8_t scsi_bus; /* SCSI Bus */ + u_int8_t scsi_id; /* SCSI ID */ + u_int16_t blksize; /* block size in bytes */ + u_int32_t blkcount; /* total blocks */ + u_int32_t blkreserved; /* reserved blocks */ + u_int8_t drv_model[40]; /* drive model */ + u_int8_t drv_serial[40]; /* drive serial number */ + u_int8_t drv_fwrev[8]; /* drive firmware revision */ + u_int8_t scsi_inq; /* SCSI inquiry bits */ + u_int8_t cpq_drv_stmp; + u_int8_t last_fail; + u_int8_t pd_flags; /* physical drive flags */ +#define PDF_DISK_PRESENT 0x01 +#define PDF_NONDISK_PRESENT 0x02 +#define PDF_WIDE_ENABLED 0x04 +#define PDF_SYNC 0x08 +#define PDF_NARROW_TRAY 0x10 +#define PDF_WIDEFAIL 0x20 +#define PDF_ULTRA 0x40 +#define PDF_ULTRA2 0x80 + u_int8_t mpd_flags; /* more physical drive flags */ +#define MPDF_SMART_SUPPORT 0x01 /* S.M.A.R.T supported */ +#define MPDF_SMART_ERRORS 0x02 /* S.M.A.R.T errors recorded */ +#define MPDF_SMART_ENABLED 0x04 /* S.M.A.R.T predictive failure is enabled */ +#define MPDF_SMART_ERR_RESET 0x08 /* S.M.A.R.T errors recorded since last reset */ +#define MPDF_DRIVE_EXTERNAL 0x10 /* Connected to external connector. */ +#define MPDF_DRIVE_CONF_LVOL 0x20 /* Configured as part of a logical volume */ +#define MPDF_DRIVE_CONF_SPARE 0x40 /* Configured as a spare */ +#define MPDF_DRIVE_WCE 0x80 /* Drive WCE set on spinup */ + u_int8_t scsi_lun; + u_int8_t ympd_flags; /* yet more physical drive flags */ +#define YMPDF_DRIVE_WCE_SET 0x40 /* WCE currently set */ +#define YMPDF_DRIVE_WCE_CHNG 0x80 /* WCE changable */ + u_int8_t reserved; + u_int32_t spi_speed_rules; + u_int8_t phys_con[2]; /* Physical Connector */ + u_int8_t phys_box; /* Physical Box on Bus */ + u_int8_t phys_bay; /* Physical Bay in Box */ +} __packed; + +/* + * CMD_BLINK_DRV_LEDS (0x16) + * Blink Drive Tray LEDs + * + * CMD_SENSE_DRV_LEDS (0x17) + * Sense Blinking Drive Tray LEDs + */ +struct ida_blink_drv_leds { + u_int32_t bd; /* Blink duration (in 10ths sec) */ + u_int32_t bte; /* Blink time elapsed (sense only) */ + u_int8_t bse[256]; /* Blink/seek enable */ + u_int8_t reserved1[248]; +} __packed; + +/* + * CMD_LABEL_LOG_DRV (0x57) + * Label Logical Drive + */ +struct ida_label_logical { + u_int32_t ld_id; /* Logical drive identifier */ + u_int8_t ld_label[64]; /* Logical drive label */ } __packed; |