diff options
| -rw-r--r-- | share/man/man4/awi.4 | 50 |
1 files changed, 15 insertions, 35 deletions
diff --git a/share/man/man4/awi.4 b/share/man/man4/awi.4 index 425d9d5..f6b5c3c 100644 --- a/share/man/man4/awi.4 +++ b/share/man/man4/awi.4 @@ -45,9 +45,7 @@ driver. The NWID doesn't affect in this mode. .Pp For more information on configuring this device, see -.Xr ifconfig 8 -and -.Xr ifmedia 4 . +.Xr ifconfig 8 . .Sh HARDWARE Cards supported by the .Nm @@ -68,6 +66,10 @@ driver include: 1Mbps Frequency Hopping PCCARD adapter .It Netwave AirSurfer Pro 2Mbps Direct Sequence PCCARD adapter +.It Nokia C020 WLAN +2Mbps Direct Sequence PCCARD adapter +.It Farallon SkyLINE +2Mbps Direct Sequence PCCARD adapter .El .Pp The original Xircom Netwave AirSurfer is supported by the @@ -89,38 +91,17 @@ For DS radio cards, mediaopt can be used for .Xr wi 4 compatible adhoc mode. +In addition to these station modes, +.Em hostap +mediaopt can be used to create a host-based access point. .Sh DIAGNOSTICS .Bl -diag -.It "awi0: unable to allocate memory space; using i/o only" -Indicates that the driver was not able to allocate 32kb of PCMCIA bus -address space into which to map the device; the driver will use the -(slightly slower) i/o-space only access methods to read and write to -the shared memory. -Since by default, -.Nx -only allocates 16kb of -address space per PCMCIA controller, this message is in some sense to -be expected and should not be a cause for alarm. -See -.Xr pcmcia 4 -for information on how to increase the memory available to the PCMCIA -controller. +.It "awi0: awi_pccard_probe: bad banner:" +The device failed to initialize its firmware. .It "awi0: failed to complete selftest (%s)" The device failed to complete its self test. -.It "awi0: synced with no-bssid at channel %d" -The device is ready to relay traffic at specified channel. -.It "awi0: synced with %s ssid %s at channel %d" -The device has successfully synchronized with at least one of the -identified stations and is ready to relay traffic. -.It "awi0: associated with %s ssid %s channel %d signal %d" -The device has successfully synchronized with the identified Access -Point and is ready to relay traffic. -.It "awi0: authentication failed (reason %d)" -.It "awi0: association failed (reason %d)" -The access point refuses the association request from the device. -.It "awi0: no recent beacons from %s; rescanning" -The device has not seen a beacon from its currently associated Access -Point recently, and is looking for a new access point. +In some circumstances, resetting device after power on fails. +Re-inserting the card or down-then-up interface may be helpful. .It "awi0: transmit timeout" The device failed to generate an interrupt to acknowledge a transmitted packet. @@ -129,16 +110,15 @@ The system was unable to obtain the lock to access shared memory. .It "awi0: command %d failed %x" The device failed to complete the request from the system. .El -.Sh BUGS -Doesn't create IBSS itself. .Sh SEE ALSO .Xr arp 4 , .Xr cnw 4 , -.Xr ifmedia 4 , +.Xr card 4 , .Xr miibus 4 , .Xr netintro 4 , -.Xr pcmcia 4 , +.Xr pccard 4 , .Xr wi 4 , +.Xr wlan 4 , .Xr ifconfig 8 .Rs .%T Am79C930 PCnet Mobile Single-Chip Wireless LAN Media Access Controller |
