Remove any mention of PCI support relating to userconfig.

Remove the comment about Mylex RAID controllers, as this has been fixed.

Approved by:	jkh (partly)

2 files changed, 5 insertions, 15 deletions

diff --git a/release/texts/HARDWARE.TXT b/release/texts/HARDWARE.TXT
index 0ce5753..ef47bf4 100644
--- a/release/texts/HARDWARE.TXT
+++ b/release/texts/HARDWARE.TXT
@@ -149,7 +149,7 @@ of these devices can be difficult to detect accurately, and for some,
 the process of detecting another can cause irreversible confusion.
 
 To make this process easier, FreeBSD provides UserConfig.  With this
-UserConfig, the user can configure and disable device drivers before
+tool the user can configure and disable device drivers before
 the kernel is loaded, avoiding potential conflicts, and eliminating
 the need to reconfigure hardware to suit the default driver settings.
 
@@ -180,7 +180,7 @@ Here is a sample UserConfig screen shot in 'visual' mode:
  Communications :
  Input :
  Multimedia :
- PCI :
+
 
 ---Parameters-for-device-ed0---------------------------------------------------
  Port address : 0x280      Memory address : 0xd8000
@@ -250,9 +250,7 @@ To finish configuring a driver, press 'Q'.
 
 Note that PCI, Microchannel and EISA devices can be probed reliably,
 therefore they are not shown in the table above nor can their settings
-be changed using UserConfig.  PCI drivers may be seen in the "PCI
-Devices" section in the Active Devices list, if you wish to check for
-their presence.
+be changed using UserConfig.
 
 
 3.      LINT - other possible configurations
diff --git a/release/texts/TROUBLE.TXT b/release/texts/TROUBLE.TXT
index 585aa30..93df07b 100644
--- a/release/texts/TROUBLE.TXT
+++ b/release/texts/TROUBLE.TXT
@@ -320,9 +320,8 @@ A: Your machine doesn't like the new i586_copyout and i586_copyin code
 
 Q: I have this CMD640 IDE controller that is said to be broken.
 
-A: Yes, it is.  There's a workaround available now and it is enabled
-   automatically if this chip is used on your system.
-   For the details refer to the manual page of the disk driver (man 4 wd).
+A: Yes, it is.  FreeBSD does not support this controller except through
+   the legacy 'wdc' driver.
 
 
 Q: On a Compaq Aero notebook, I get the message "No floppy devices found!
@@ -384,13 +383,6 @@ A: There is a problem with the onboard Ethernet in the Netfinity 3500
    will have to install another Ethernet adapter and avoid attempting
    to configure the onboard adapter at any time.
 
-Q: When I install to my Mylex RAID controller and reboot, I get a register
-   dump, or the system is extremely slow in booting.
-
-A: Due to incompatibilities between the Mylex BIOS and the FreeBSD
-   bootloader, the Mylex BIOS must be disabled.  This means that you 
-   cannot boot from a RAID array at this time.
-
 Q: When I install to my AMI RAID controller and reboot, the kernel 
    cannot mount root, even though the AMI controller was detected.