Two small fixes:

  Set promiscuous code was unconditionally turning off multicast when
  turning off promiscuous mode, this should only be done when there are
  less than MAX groups. Thanks to Mike Karels for this correction.

  Second, the overtmp interrupt setup/detection was wrong, correcting it.

MFC after:	one week

1 files changed, 36 insertions, 8 deletions

diff --git a/sys/dev/ixgbe/ixgbe.c b/sys/dev/ixgbe/ixgbe.c
index 9977803..2ca62f0 100644
--- a/sys/dev/ixgbe/ixgbe.c
+++ b/sys/dev/ixgbe/ixgbe.c
@@ -47,7 +47,7 @@ int             ixgbe_display_debug_stats = 0;
 /*********************************************************************
  *  Driver version
  *********************************************************************/
-char ixgbe_driver_version[] = "2.5.7 - HEAD";
+char ixgbe_driver_version[] = "2.5.8 - HEAD";
 
 /*********************************************************************
  *  PCI Device ID Table
@@ -1639,11 +1639,11 @@ ixgbe_msix_link(void *arg)
 
 	/* Check for over temp condition */
 	if ((hw->mac.type == ixgbe_mac_X540) &&
-	    (reg_eicr & IXGBE_EICR_GPI_SDP0)) {
+	    (reg_eicr & IXGBE_EICR_TS)) {
                 device_printf(adapter->dev, "\nCRITICAL: OVER TEMP!! "
 		    "PHY IS SHUT DOWN!!\n");
                 device_printf(adapter->dev, "System shutdown required\n");
-		IXGBE_WRITE_REG(hw, IXGBE_EICR, IXGBE_EICR_GPI_SDP0);
+		IXGBE_WRITE_REG(hw, IXGBE_EICR, IXGBE_EICR_TS);
 	}
 
 	IXGBE_WRITE_REG(&adapter->hw, IXGBE_EIMS, IXGBE_EIMS_OTHER);
@@ -1892,10 +1892,34 @@ ixgbe_set_promisc(struct adapter *adapter)
 {
 	u_int32_t       reg_rctl;
 	struct ifnet   *ifp = adapter->ifp;
+	int		mcnt = 0;
 
 	reg_rctl = IXGBE_READ_REG(&adapter->hw, IXGBE_FCTRL);
 	reg_rctl &= (~IXGBE_FCTRL_UPE);
-	reg_rctl &= (~IXGBE_FCTRL_MPE);
+	if (ifp->if_flags & IFF_ALLMULTI)
+		mcnt = MAX_NUM_MULTICAST_ADDRESSES;
+	else {
+		struct	ifmultiaddr *ifma;
+#if __FreeBSD_version < 800000
+		IF_ADDR_LOCK(ifp);
+#else
+		if_maddr_rlock(ifp);
+#endif
+		TAILQ_FOREACH(ifma, &ifp->if_multiaddrs, ifma_link) {
+			if (ifma->ifma_addr->sa_family != AF_LINK)
+				continue;
+			if (mcnt == MAX_NUM_MULTICAST_ADDRESSES)
+				break;
+			mcnt++;
+		}
+#if __FreeBSD_version < 800000
+		IF_ADDR_UNLOCK(ifp);
+#else
+		if_maddr_runlock(ifp);
+#endif
+	}
+	if (mcnt < MAX_NUM_MULTICAST_ADDRESSES)
+		reg_rctl &= (~IXGBE_FCTRL_MPE);
 	IXGBE_WRITE_REG(&adapter->hw, IXGBE_FCTRL, reg_rctl);
 
 	if (ifp->if_flags & IFF_PROMISC) {
@@ -4734,11 +4758,11 @@ ixgbe_setup_vlan_hw_support(struct adapter *adapter)
 static void
 ixgbe_enable_intr(struct adapter *adapter)
 {
-	struct ixgbe_hw *hw = &adapter->hw;
-	struct ix_queue *que = adapter->queues;
-	u32 mask = (IXGBE_EIMS_ENABLE_MASK & ~IXGBE_EIMS_RTX_QUEUE);
-
+	struct ixgbe_hw	*hw = &adapter->hw;
+	struct ix_queue	*que = adapter->queues;
+	u32		mask, fwsm;
 
+	mask = (IXGBE_EIMS_ENABLE_MASK & ~IXGBE_EIMS_RTX_QUEUE);
 	/* Enable Fan Failure detection */
 	if (hw->device_id == IXGBE_DEV_ID_82598AT)
 		    mask |= IXGBE_EIMS_GPI_SDP1;
@@ -4755,6 +4779,10 @@ ixgbe_enable_intr(struct adapter *adapter)
 			break;
 		case ixgbe_mac_X540:
 			mask |= IXGBE_EIMS_ECC;
+			/* Detect if Thermal Sensor is enabled */
+			fwsm = IXGBE_READ_REG(hw, IXGBE_FWSM);
+			if (fwsm & IXGBE_FWSM_TS_ENABLED)
+				mask |= IXGBE_EIMS_TS;
 #ifdef IXGBE_FDIR
 			mask |= IXGBE_EIMS_FLOW_DIR;
 #endif